Maxtor MV-DR3000 Hard-disk Drive Installation, Attaching an External Device to DVR, Ide

INSTALLATION ( continued )

D. Attaching an External Device to DVR

Connect an alarm out, alarm input, and a peripheral device as shown in the diagram below.

	FROM MUX
VIDEO	MAIN MONITOR
		AUDIO	RS-485
	IN	IN
		ETHERNET	RS-232
		10/100
	OUT	OUT
TO	TO		ALARM	I/O
MUX'S VCR IN	MONITOR				DC12V

Lamp

Alarm Reset

(Normally Open)

5 4 3 2 1

Ground 9 8 7 6

Alarm in

(Normally Open)

2.2 Hard-disk Drive Installation

The DVR is equipped with two compartments of hard disk drive (for removable model only), The unit usually comes with one hard-disk drive installed in the compartment HD1, which is default- configured as a master. If you need a second hard-disk drive to be installed in the compartment HD2 (Mobile), please contact your distributors or installers for specific instructions on how to install it. Please don’t serve yourself before consulting your installers. If there is only one hard-disk drive in the mobile compartment, please set

the HD2 USAGE option to REC (please refer to section 4.5) before proceeding with the recording function. The jumper-settings arrangement of installed hard-disk drives for the system (Table 3.2 A.) is shown in the tables below.

Note: The CD-RW model is equipped with a fixed hard- disk and a CD-RW drive. The unit usually comes with one hard-disk drive installed in the compartment HD1, which is default-configured as a master.

Table 3.2 A. The jumper settings of hard-disk drives in the system

	Location	Jumper
IDE 1	Compartment HD 1	Master (Default)
IDE 2	Compartment HD 2	Master

11