Maxtor MV-DR3000 operation manual O.S.D Message, D Message Meanings

7.4 O.S.D Message

No.	O.S.D Message	Meanings
1	NO DISK	No hard-disk detected after power activated.
2	BATTERY LOW	Suggest change the battery and reset the system
		time.
3	LOADING	System Boot up.
4	VIDEO LOSS	Video loss.
5	VIDEO IN	Video input source.
6	KEY LOCKED	Key lock function is on.
7	KEY UNLOCKED	Key lock function is off.
8	n1 OF n2 ITEMS PROGRESS n3 %	BACKUP n1/n2 NOW.
9	BACKUP COMPLETE	Backup complete.
10	HD2 SPACE NOT ENOUGH	HD2 has not enough space for backup.
11	NO ENTRY FOR BACKUP	No backup is possible.
12	BACKUP INCOMPLETE	Backup incomplete, since the user has pressed
		the STOP button to stop it.
13	NOT FOUND	The system cannot find a video in the Search
		function.
14	END	Playback of recorded video has reached the end
		point.
		Hard-disks are full; this happens only when the
15	DISK FULL	DISK FULL item in the setup menu is set to
		STOP.
16	EMPTY	The user presses the PLAY button or uses the
		SEARCH function, but no video can be played.
17	SET TO NTSC, PLS RESTART	System has to be set to NTSC, please reboot
		(PAL is similar).
18	SOFTWARE UPDATE	Software update.
19	PLEASE RESTART	The system should be rebooted after the software
		has been updated.
20	NO DISK	The user has pressed the Save key without
		putting in an SD card, or there is a disk error.
		The system finds data in installed HDs cannot be
21	DATA NOT CONTINUOUS	used contiguously. Suggest you remove HD2
		from the system.
22	DISK ATTACHED	HD2 has been attached.
23	DISK REMOVED	HD2 has been removed.
24	FAN STOPPED	The chassis fan has stopped for over 30 seconds.
		There has been a hard-disk error during
25	HDn ERROR AT xxxxx	recording, where n is the hard-disk number and
		xxxxx is the hexadecimal location.
26	NOT PRESENT	When the user tries to clear a disk that was not
		attached in the setup menu.
27	SAVE TO DISK	Start saving to the JPEG file.
28	SAVE TO Fnnn. JPG	Saving to Fnnn. JPG (where nnn= 0..999)
29	SAVE OK	Save to the JEPG is ok.
30	SD CARD WRITE PROTECTION	An SD card is write-protected; or, there is an
		error.

81