Maxtor MV-DR3000 operation manual Updating System Software, Quality Best Ntsc Rate 6HR, MUX on

Press the Display button 8 once; the DVR will display the following sample message plus the default display. Press the Display button

8again; the unit will not display any OSD message. Press the button one more time to go back to the default display.

1+2 :59G 12.4 HR

QUALITY : BEST	NTSC
RATE :6HR	20 F/S
MUX :ON	9K

HD SIZE REC PLAY 1 20G 10.0% 0.1%

239G 0.0% 0.0% (For removable HDD model only)

CD 133M 80.0% (For CD-RW model only)

IP : 192.168.1.90

14-04-2005 09:46:53

Total capacity of installed hard disk: 59 GB.

(12.4 HR): Total 12.4 hour recording time available.

(	): Timer record activated.
(	): Alarm record activated.
(	): motion detection activated.

(QUALITY: BEST): Record quality setting: BEST.

(NTSC ): NTSC system.

(RATE: 6 HR): Setting of Record time mode: 6 hours.

(20 F/S): Record speed setting: 20 fields/sec.

(MUX: OFF): Only connected to a single camera.

(	): Audio function activated.
(	): Indicates which HDD is activated.
( 9K ): The image file size.
( HD ): Hard-disk compartment.(HD2 IS FOR
REMOVABLE MODEL ONLY)
(CD):CD-RW Compartment. (FOR CD-RW MODEL
ONLY)

( SIZE 20G): The capacity of the installed hard disk.

( REC ): Percentage of system Recording.

( PLAY ): Percentage of system Playback.

( IP : 192 . 168 . 1 . 90 ): Network IP Address 192.168.1.90

(	): External signal.
(	x ): Cannot operate now.

2.4 Updating System Software

13 12

Please take the following steps to safely update it.

1.Inserting your SD card into your SD card reader.

2.Plug your card reader's USB connector into your PC.

3.Save the firmware ( the multi.bin file ) into the SD card.

4.After you have checked that the saving is complete, take the SD card out of the card reader.

5.Turn off the DVR.

6.Insert the SD card into the built-in SD slot of the unit.

7.Hold down the the Up 12 and Down 13 buttons simultaneously, and then turn on the DVR.

8.Keep holding down the buttons until the DVR sounds a tone and display the message

“ XXXXXX BYTES READ” Now the DVR is updating the system software, which will take approximately 90 seconds to process.

9.Restart the unit when the device sounds a tone twice and displays the message “PLEASE RESTART” The process is complete.

(If you have already followed the procedure 1~9. the unit, however, not being able to power on. Please first check if the SD card you are using is functioning and the file is intact. And then start procedures 1 ~ 9 all over again.)

10.Verify the version of the system software from the “MAIN MENU -> SYSTEM -> VERSION” by push down Setup button. (Please refer to section 4.6 VERSION.)

!Caution:

1.Before carrying out the updating procedures, please ensure the SD card is working and the file of system software is intact.

2.Don’t interrupt the process while the unit is updating itself, as this will cause the unit to crash.

13