Philips SRU 5010 86 Instructions for use Contents, Introduction, Installing the remote control

English

Instructions for use
	Contents
1.	Introduction	. . . . 4
2.	Installing the remote control	. . 4-6
	Inserting the batteries	. . . . 4
	Testing the remote control	. . . . 4
	Setting the remote control	. . . . 5
3.	Keys and functions	. . . . 7
4.	Extra possibilities	. . . . 8
	Adding a function to the remote control	. . . . 8
	Restoring the original functions of your remote control	. . . . 8
5.	Troubleshooting	. . . . 8
6.	Need help?	. . . . 9
	Code list of all brands / equipment	52-60
	Information to the Consumer	. . 62
1.	Introduction
Congratulations on your purchase of the Philips SRU 5010 universal remote
control. After installing the remote control it can operate the most-used
functions of almost any brand of TV.
You can find information about how to prepare this remote control for use in
the chapter ‘Installing the remote control’.
2.	Installing the remote control
Inserting the batteries

1Press the cover inwards and slide it in the direction of the arrow.

2Place two AAA type batteries into the battery compartment, as shown.

3Slide the cover back and click it firmly into place.

Note: If the LED blinks four times after every key press, the remote control is indicating that its batteries are running low. Replace the old batteries with two new AAA batteries.

Testing the remote control

The remote control has been programmed to operate the most-used functions of almost any brand of TV. Because the SRU 5010 may use different signals for each make and even for different models of the same brand, it is advisable to test whether your TV responds to the SRU 5010.

The example below instructs you how to do this.

1Turn your TV on manually or use the original remote control. Tune to channel 1.

2Check whether all the keys are working For an overview of the keys and their functions see ‘3. Keys and functions’.

–If the TV responds as it should to all of the key commands the SRU 5010 is ready for use.

•If the TV does not respond at all or not to all of the key commands, follow the instructions under ‘Setting the remote control’, or for online setup go to: www.philips.com/urc.

4