Philips SRU 5010 86 manual Manually setting the remote control, Start again from step

English

Instructions for use

Manually setting the remote control

1Turn on the TV manually or use the original remote control. Tune in to channel 1.

2Look up the brand of your TV in the

code list at the back of this manual. One or more four-figure codes are shown for each brand. Note the first code.

On our website www.philips.com/urc you can directly select your device typenumber to find the right code.

3Keep keys 1 and 3 pressed simultaneously for three seconds until the LED

flashes twice and then remains lit

4Then enter the code noted in step 2 using the digit keys.

–The LED will now flash twice and then remains lit.

The code has now been stored in the memory of the SRU 5010.

If the LED flashes once for an extended period, the code has not been entered properly or the wrong code has been entered.

Start again from step 2.

5Point the SRU 5010 at the TV and check that it responds as it should.

– If the TV responds to all of the key commands, the SRU 5010 is ready for use. Do not forget to note your code.

•If the TV does not respond at all, or not to all of the

key commands, start again from step 2 and try the next code from the list.

6