Philips SRU5060 After the SRU 5060 has run through all the known codes, Start again from step

English

Instructions for use

•If this is not the case, you can redo the automatic setting. The SRU 5060 will then search for a code that works better.

–After the SRU 5060 has run through all the known codes,

the search will stop automatically and the Standby key will stop flashing.

–Automatic programming of a TV takes a maximum of 5 minutes. For DVD, CD,VCR, AMP and STB this time is 2 minutes.

Manually setting the remote control

Example of TV:

1Turn on the TV manually or use the original remote control. Tune in to channel 1.

2Look up the brand of your TV in the code list at the back of this manual.

One or more four-figure codes are shown for each brand. Note the first code.

Be careful! There are separate tables for TV, video, DVD, etc.

On our website www.philips.com/urc you can directly select your device typenumber to find the tight code.

Make sure you use the codes from the correct table.

3Press the SELECT key to select TV.

Press the key until the Standby key lights up.

4Keep keys 1 and 3 pressed simultaneously for three seconds until the Standby key

flashes twice and then remains lit.

5Then enter the code noted in step 2 using the digital keys.

– The Standby key will now flash twice.

If the key flashes once for an extended period, the code has not been entered properly or the wrong code has been entered.

Start again from step 2.

6Point the SRU 5060 at the TV and check that it responds as it should.

– If the TV responds to all of the key commands, the SRU 5060 is ready for use. Do not forget to note your code.

•If the device does not respond at all, or not to all of the

key commands, start again from step 2 and try the next code from the list.

6