Sylvania 6900DTE owner manual Precautions, Location

Page 5

Before Using

Precautions

1

Location

For safe operation and satisfactory performance of this product, keep the following in mind when select- ing a place for its installation:

Shield it from direct sunlight and keep it away from sources of intense heat.

Avoid dusty or humid places.

Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes at the top and bottom of the unit. Do not place the unit on a carpet because this will block the ventila- tion holes.

Install unit in a horizontal position.

Avoid locations subject to strong vibration.

Do not place this product near strong magnetic fields.

Avoid moving this product to locations where tem- perature differences are extreme.

Avoid the Hazards of Electrical Shock and Fire

Do not handle the power cord with wet hands.

Do not pull on the power cord when disconnecting it from an AC wall outlet. Grasp it by the plug.

If by accident, water is spilled on your unit, unplug the power cord immediately and take the unit to our Authorized Service Center for servicing.

Do not put your fingers or objects into this product cassette holder.

Do not place anything directly on top of the unit.

IMPORTANT COPYRIGHT INFORMATION

Unauthorized recording or use of broadcast televi- sion programming, video tape, film or other copy- righted material may violate applicable copyright laws. We assume no responsibility for the unautho- rized duplication, use or other acts which infringe upon the rights of copyright owners.

FCC WARNING- This equipment may gener- ate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction man- ual. The user could lose the authority to oper- ate this equipment if an unauthorized change or modification is made.

This equipment has been tested and found to com- ply with the limits for a Class B digital device, pur- suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be deter- mined by turning the equipment off and on, the user is encouraged to try to correct the interfer- ence by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a cir- cuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

Before Using

The serial number of this product may be found on the back of the unit. No others has the same serial number as yours. You should record the number and other vital information here and retain this book as a permanent record of your purchase to aid identification in case of theft. Serial numbers are not kept on file.

Date of Purchase

Dealer Purchase from

Dealer Address

Dealer Phone No.

Model No.

Serial No.

5

EN

1A23

Image 5
Contents 6900DTE Indice Table of ContentsImportant Safeguards S2 8 9 8 a Location PrecautionsReceives Atsc Information on digital broadcastingDolby Digital Major features of STBSub-Channel Smart AntennaNavigation buttons o / p / s / B Moves Location of controls12 11 Snap the battery cover back Accessories Installing batteriesFor details Rear panel of STB Connecting the Smart AntennaRefer to your television’s manual for details Connecting a different antennaCable BOX Antenna Connections STB connection using DVI-D Hdcp OUT jack to Hdtv Connections TV/Monitor STB connection using COMP. OUT jacks to Hdtv TV/Monitor Connections Connection to Sdtv Digital Decoder STB connection to a decoder with Dolby DigitalStereo Component STB connection to a standard stereo system4Other Connections STB starts scanning channels Initial setupSelect Setup using navigation buttons Then press Enter Press Enter when the cursor is on SET Setup Wizard 3/8 appearsSetup Wizard 4/8 appears Setup Wizard 5/8 appearsTo select SET and press Enter Setup Wizard 8/8 appearsSetup Wizard is completed. STB starts receiving broadcasts Watching TV PowerSelecting channels Enter CH ReturnTo select only with a main channel number E.g About sub-channel broadcastingAtsc To return to the channel you were last watchingPress Info to display the channel banner Channel bannerPress Info to clear InfoDTV Components of Channel BannerLock CHIP/CCPress Audio Choosing audio and languageAudio map AudioPress Still o button while watching Picture StillPress any button to quit StillOn screen messages No SignalScanning Restricted ProgramPress Enter Press EPG button while watching TVPrevious EPGTo clear the EPG Components of Electronic Program Guide EPGSetup menu options Setup Press Setup to display Setup menuAdding/Deleting channels Channel menu appearsPress Enter when the cursor is on the digital channel Select ADD using navigation buttons o Then press EnterPress Setup to exit Setup menu Enter channel numberInformation on channel map Antenna Adjusting antennaNavigation buttons To adjust channel Autoscan Receiving channelsAntenna to get the best reception When no Signal appears on the screen To cancel during scanningAutoscan Cancelled appears on the screen Scan is completedScreen Ratio Selecting screen formats Screen ratio and Display modeDisplay menu appears Screen ratio options appearImportant information about screen ratio and display mode Display Mode43 TV 169 TVZoom Letter BoxFull SidebarSelect DST using navigation buttons o / p, then press Enter Setting the clockSelect Clock using navigation buttons Then press Enter Current time setting menu appears Time Zone setting menu appearsYour settings are activated To go back and forth, press navigation buttons s / BSelect Auto using navigation buttons Then press Enter Adjusting the clock AutomaticallyWhen not using the auto-clock setting After scanningChip options Setting a new passwordCHIP/CC menu appears Select Detail using navigation button Then press EnterEnter the default password Enter your 4-digit password Setting for V-CHIP/CCSelect Detail using navigation buttons Then press Enter If you choose TVto control V-CHIP Ratings CHIP/CC setting menu appearsIf you choose STBto control V-CHIP Ratings Mpaa Rating Setting Mpaa ratingMpaa rating setting menu appears Select Detail using navigation buttonsLock indicators are added to programs rated PG-13 and above To block all PG-13 moviesTV Rating Setting TV ratingInformation on TV ratings TV rating setting menu appearsTo set age-based ratings To block all TV-14 programs Press Setup to exit Setup menuClosed Caption Closed caption optionsCC3 and TEXT3 CC2, CC4, TEXT2 and TEXT4Closed Caption menu appears Then press Enter Enter your 4-digit passwordClosed Caption selection screen appears Closed Caption menu appears Your selection is activatedGo to step CC Style preview screen appears Select SET using navigation buttons s Then press EnterOpacity selection screen appears Menu Language Choosing the screen languageLanguage menu appears Language you select is now used for on-screen displaysSound Effects Sound effects are only when using on screen menuChoosing sound effects Troubleshooting Extended Scan Glossary and Acronyms SpecificationsDigital Audio OUT OPT. or COAX. jack PasswordElectronic Program Guide EPG Video output jackUbicación del control Antes de utilizarMando a Distancia Panel FrontalDVI-D Hdcp OUT en Hdtv Conexiones de antenaConexiones de TV/Monitor Conexión STB a un Decodificador con Dolby Digital Otras conexionesAjuste inicial Conexión STB a un sistema Estéreo normalConsejo Memo 0EMN02517 Van Ness Avenue, Torrance, CA