Baldor iMN1921 installation manual Loading saved information

Page 46

4. On the main menu, choose File, Save File. Locate a folder, enter a filename and click Save.

5.6.1Loading saved information

1.In the Toolbox, click the Edit & Debug icon.

2.On the main menu, choose File, Open File...

Locate the file and click Open.

A Startup block should be included in every Mint program, so that whenever a program is loaded and run the NextMove ST will be correctly configured. If the same program is used on a different NextMove ST installation, remember the Startup block might need to be changed to accommodate a different motor type.

5-12 Operation

MN1921

Image 46

Contents NextMove ST Motion Controller Page Contents Operation General Information Safety Notice PrecautionsNextMove ST features MN1921 IntroductionReceiving and inspection Phase Units and abbreviationsIntroduction MN1921 Introduction You should read all the sections in Basic InstallationLocation requirements Package dimensions Mounting the NextMove STOther requirements for installation Basic Installation MN1921 Input / Output Connector locations Power connections Operation using combined drive and logic supplyOperation using separate drive and logic supplies Connecting separate drive and logic suppliesStepper outputs Connecting a 4-wire motorStepper axes 0-2 drive outputs Connecting a 6-wire motor Connecting a 8-wire motor Connecting a 8-wire motor, parallel windingsStepper axes 0-3 logic outputs Stepper output pin header J3, and output circuit shownAnalog I/O Analog inputsAnalog output Analog outputDigital I/O Digital inputsUsing a digital input as an Error input Using a digital input as a Limit or Home inputUsing a digital input as a Stop input Auxiliary Encoder inputs Auxstep IN, Auxdir IN, AuxzDigital outputs Digital output DOUT0 shownGlobalerroroutput keyword Error outputDriveenableoutput keyword Jumper settingsLocation Other I/ORS232 serial communication Pin Name Description2 50-pin edge connector RS232 serial port connectionsCan communication Typical can network connectionsJP1 This will connect an internal terminating resistor CANopen and Baldor canConnection summary minimum system wiring Host PCInput / Output MN1921 Starting the NextMove ST Connecting the NextMove ST to the PCInstalling WorkBench Preliminary checksPower on checks WorkBench Help fileStarting WorkBench MN1921 Operation Configuring an axis Selecting a scaleClick Apply Stepper axis testing Testing the output Digital input/output configuration Digital input configurationDigital output configuration Saving setup information Loading saved information Problem diagnosis SupportMe featureNextMove ST indicators Status displaySurface mount LEDs D3, D4 and D16 Communication Symptom CheckMotor control Input power Output power ValueEquivalent resolution ±10V input Common mode voltage rangeInput impedance 120 Input ADC resolution Bits Output current max Update interval ImmediateOutput current maximum, per axis Stepper axis 0-2 drive outputsUnit Value Maximum output frequency KHz 200 Output voltage Unit Value Output typeEnvironmental Unit Value SignalCan interface Channels Protocols CANopenIndex Index MN1921 Comments CommentComments MN1921 Page LT0184A00