Graco PD169096A owner manual Adjusting Head Support in Booster Mode, Removing Back Support

Page 26

18.0 Adjusting Head Support in Booster Mode

	BEFORE adjusting the head support height,
	have your child lean forward slightly.
	have your child lean forward slightly.

Squeeze the red adjustment handle on top of seat and pull back support up until it snaps into one of the 5 height positions .

To lower, squeeze red adjustment handle and push down.

19.0 Removing Back Support

To use booster seat WITHOUT back support, remove harness straps if attached (see section 15.0 Harness Removal, p.41-45) then continue with the following steps:

1. Detach 2 lower elastic straps from rear of

seat as shown .

CHECK to make sure it is securely snapped into one of the 5 height positions by pulling up on head support.

The shoulder belt guides must be even with or just above the shoulders as shown by dotted line .

2. Detach elastic strap from the hooks on the

seat pad as shown. Repeat on other side .

50

51

Image 26

Contents Rgos Table of Contents Page Model Number Manufactured Purchase Date Register Your Child RestraintFeatures Assembling the Child Restraint Harness Strap Arm SlotPage AN Accident of ANY KIND. An accident Unsecured in Your VEHICLE. AnVery HOT if Left in the SUN. Contact with Damaged or Missing PARTS. Do not useWithout Built-in Harness Height and Weight LimitationsWith Built-In Harness Your child must meet all requirementsWithout Back Support Choosing an Appropriate Vehicle Seat LocationSafe Vehicle Seat Belt Systems Vehicle Seat Belt RequirementsFor Built-in Harness Only ‡ Lap Belts with Automatic Locking Retractor ALRRepeat above steps until secure With or Without Built-in Harness To Install Locking Clip‡ Combination LapShoulder Belt with Locking Latch Plate ‡ Combination LapShoulder Belt with Retractor Unsafe Vehicle Belt Systems‡ Lap Belts with Emergency Locking Retractor ELR ‡ Lap Belts Forward of Seat CreaseWhat is LATCH? LatchUsing Child Restraint with Built-in Harness Latch SystemUnbuckle harness straps œ Tighten vehicle seat belt Safety Check for Secure InstallationSecuring the Child Restraint in Your Vehicle Location, pWith Latch Lay flat and not be twistedSecuring Your Child in the Child Restraint ‡ Avoid bulky clothingMust above the shoulders œ Adjusting Head Support/Harness StrapsHarness straps must be even with or To prevent serious injury or death Check Harness SystemHarness Removal To use without built in harness Remove harness strapsPage Harness Strap Using Your Child Restraint Without Built-in Harness Securing Child & Booster Seat in Vehicle Adjusting Head Support in Booster Mode Removing Back SupportPage Page Correct Incorrect Using the Tether Storing Lower Anchors and Tether Latch Important points to remember To prevent ejection in sudden stop or crashCare and Maintenance Recline FootTo Remove Head Support and Seat Covers Bleach