Graco PD169096A owner manual

Page 28

20.0Securing Child in Vehicle with Shoulder Belt Positioning Clip

The shoulder belt MUST lie across child’s shoulders in red zone as shown ™.

If shoulder belt lies outside this zone, the

 

shoulder belt positioning clip MUST be used.

™

 

To attach clip to booster seat:

 

1. Insert the loop end of strap through the slot

 

on rear of seat exactly where shown š.

 

There is a slot on each side of booster seat,

 

the shoulder belt positioning clip MUST be

 

attached through the slot closest to where the

 

vehicle shoulder belt lies across the child.

š

 

2.Pass the clip and the strap through the loop end ›as shown and pull strap up.

3.NOTE: Free end of strap œ should face front of seat.

›

œ

54

55

Image 28
Contents Rgos Table of Contents Page Model Number Manufactured Purchase Date Register Your Child RestraintFeatures Assembling the Child Restraint Harness Strap Arm SlotPage Unsecured in Your VEHICLE. An Very HOT if Left in the SUN. Contact withAN Accident of ANY KIND. An accident Damaged or Missing PARTS. Do not useHeight and Weight Limitations With Built-In HarnessWithout Built-in Harness Your child must meet all requirementsWithout Back Support Choosing an Appropriate Vehicle Seat LocationVehicle Seat Belt Requirements For Built-in Harness OnlySafe Vehicle Seat Belt Systems ‡ Lap Belts with Automatic Locking Retractor ALR‡ Combination LapShoulder Belt with Locking Latch Plate With or Without Built-in Harness To Install Locking ClipRepeat above steps until secure Unsafe Vehicle Belt Systems ‡ Lap Belts with Emergency Locking Retractor ELR‡ Combination LapShoulder Belt with Retractor ‡ Lap Belts Forward of Seat CreaseWhat is LATCH? LatchUsing Child Restraint with Built-in Harness Latch SystemUnbuckle harness straps œ Safety Check for Secure Installation Securing the Child Restraint in Your VehicleTighten vehicle seat belt Location, pWith Latch Lay flat and not be twistedSecuring Your Child in the Child Restraint ‡ Avoid bulky clothingHarness straps must be even with or Adjusting Head Support/Harness StrapsMust above the shoulders œ Check Harness System Harness RemovalTo prevent serious injury or death To use without built in harness Remove harness strapsPage Harness Strap Using Your Child Restraint Without Built-in Harness Securing Child & Booster Seat in Vehicle Adjusting Head Support in Booster Mode Removing Back SupportPage Page Correct Incorrect Using the Tether Storing Lower Anchors and Tether Latch Important points to remember To prevent ejection in sudden stop or crashCare and Maintenance Recline FootTo Remove Head Support and Seat Covers Bleach