GTO GP-SW050 owner manual Setting the Limits, Open Limit Setting

Setting the Limits

CAUTION: Be extremely careful not to stand in the path of the gate arm while setting limits.

OPEN LIMIT SETTING:

1.Turn on operator power.

2.Press and release the OPEN button on the board and be prepared to press the STOP button when the gate reached the desired open position/limit.

3.The JOG buttons can be used to bring the gate to the precise open position. The JOG buttons will slowly run the gate when pressed and stop the gate when released.

4.Once at the desired open position, press and hold the SET LIMIT button for 3 seconds or until the alarm sounds and STATUS LED is on. At this time, release the SET LIMIT button.

5.Be prepared to stop the gate when it reaches the closed position.

CLOSED LIMIT SETTING:

1.If not already closed, press and release the close button.

2.Press and release the CLOSE button on the board and be prepared to press the STOP button when the gate reached the desired closed position/limit.

3.The JOG buttons can be used to bring the gate to the precise closed position. The JOG buttons will slowly run the gate when pressed and stop the gate when released.

4.Once at the desired closed position, press and hold the SET LIMIT button for 3 seconds or until the alarm sounds and STATUS LED is on. At this time, release the SET LIMIT button.

5.Open the gate to allow it to stop on its own.

6.Open and close the gate to verify proper operations. If limits are not set properly, redo limit setting steps above.

NOTE: If limits are too short, use jog button to move arm short distances to stop gate at

the precise open or closed position.CLOSE
RUN 2		EDGE
OPEN		OPEN	MIN	MAX	MIN	MAX	OFF	120
CLOSE		CLOSE	LIMIT ADJUSTMENTS				SET SET
		STOP	<<<	JOG	>>>		LIMITLIMIT
STOP
COM	COM	W1
		CUT TO USE
	COM
		3 BUTTON		TEST SWITCHES
COM		STATION
COM	COM		CLOSE		STOP		OPEN
	GTO Inc. Tallahassee, FL
	SX4000 Logic	Board	Rev. E

17