GTO GP-SW050 owner manual Output Connections, Lock COM and Lock N.O. / Lock N.C. Lock relay output

Output Connections

Note:

• Maximum rating for all relay outputs are 24Vac/dc, 1 Amp.

• All relay outputs are dry contact (no voltage) switching.

• All outputs have corresponding LED indicator for diagnostic purposes.

The corresponding LED indicator will be lit when its relay is activated.

1.CLOSED 1 and CLOSED 2: At closed limit relay output.

• These two (2) terminals are shorted when gate is at the closed limit.

2.RUN 1 and RUN 2: Gate moving relay output.

• These two (2) terminals are shorted whenever the gate is moving/running.

RUN 1

RUN 2

CLOSED 1

CLOSED 2

RELAY OUTPUTS

RUNNI

CLOSED

3.LOCK COM and LOCK N.O. / LOCK N.C.: Lock relay output

•This relay output is designed for use with either mechanical or mag-lock device. The relay is activated (releasing the lock) during the first and the last 2-4 seconds of gate running.

Example A: Mag-Lock Connection: Use LOCK COM and LOCK NC terminals. The diagram below is for a typical mag-lock connection. Refer to the mag-lock manual for detailed operations.

Example B: For locks that are energized to release: Use LOCK COM and LOCK NO terminals.

Example A

Mag Lock

24vDC Max, 1 Amp Max

LOCK N.C.

LOCK COM

LOCK N.O.

To positive (+) terminal of mag-lock power supply

To negative (-) terminal of mag-lock power supply

REL

LOCK

LED11

RUNNING

Example B

Lock Coil or Controller 24vDC Max, 1Amp Max

LOCK N.C.

LOCK COM

LOCK N.O.

To positive (+) terminal of

Lock power supply

To negative (-) terminal of

Lock power supply

RE

LOCK

LED11

RUNNING

22