GTO GP-SW050 owner manual Stall Force and Auto-Close Adjustments, Stall Force Adjustment

Stall Force and Auto-Close Adjustments

Stall Force Adjustment:

IMPORTANT: For safety reasons, the STALL FORCE potentiometers are set at the “10 o’clock” position at the factory.

The obstruction sensitivity is independently adjustable for each direction of travel. Upon sensing an obstruction, the gate will stop and reverse direction for approximately 2 seconds.

1.Turning the potentiometer clockwise (toward the MAX position) increases the amount of force the operator applies to an obstruction. Turning the potentiometer counter-clockwise (toward the MIN position) decreases the amount of force the operator applies to an obstruction.

2.Use a small screwdriver to adjust the appropriate potentiometer and operate the gate until it can run without obstructing and reversing direction.

LOCK N.O.		RUNNING
	RELAY					DIAG.
RUN 1		LED10				PORT
	OUTPUTS
RUN 2						OPTIONS
		CLOSED
			OFF		ON	MODE 1
CLOSED 1		LED09
			OFF		ON	MODE 2
CLOSED 2			<<<	1	ON >>>	OPEN DIR.
			DELAY	2	SIMUL	SLV OPN
			MASTER	3 4	SLAVE	DUAL MODE
CYCLE		CYCLE	SAFE		SECURE	LOW BATT

SAFETY	SAFETY	STALL FORCE ADJUST				AUTO	CLOSE
SHADOW	SHADOW	<<<		>>>		TIMER
LOOP
	OPEN
OPEN EDGE	EDGE
	CLOSE
RUN 2	EDGE
OPEN	OPEN	MIN	MAX	MIN	MAX	OFF	120
CLOSE	CLOSE	LIMIT ADJUSTMENTS				SET
	STOP	<<<	JOG	>>>		LIMIT
STOP

Auto-Close Adjustment:

The Auto-Closepotentiometer allows the user to set the time that the gate will stay at the open position/limit before it automatically starts to close the gate.

This feature can be turned off by turning the AUTO CLOSE TIMER potentiometer all the way counter- clockwise. It is shipped from the factory in the OFF position (auto close feature is disabled).

•The auto close time is adjustable from 3-120 seconds.

•This feature is only enabled when the gate is at the open limit.

•This feature is disabled if the following inputs are activated.

•OPEN, SAFETY, SHADOW, CLS-EDGE or STOP.

18