GTO GP-SW050 owner manual Gate Arm Connection Overview, Right Mounted Arm

Page 17

Gate Arm Connection Overview

Right Mounted Arm

Center point of gate hinge

Center point

to center of gate bracket pin

(approximately) 50”

of gate hinge

Column

Closed Gate	Range of
	Range of
5°-10°	Arm Movement
5°-10°	160°-175°
	Housing
	Pivot point
	of operator

Opened Gate

CAUTION:

DO NOT STAND

IN THIS AREA

IMPORTANT: Be sure the operator housing will not be hit by a fully open gate and that the gate column will not interfere when housing is installed.

NOTE: All work on operator requires disconnecting AC power and batteries !

14

Image 17

Contents GP-SW050 Vehicular gate operator class categories Conversion ChartTable of Contents Important Safety Instructions for the System Designer III. After Installation Before InstallationMeans of Protection Against Entrapment Important Safety Instructions for the Consumer/End User Entrapment Protection Required Safety Precautions for GatesMoving Gate Can Cause Injury Or Death Motor Technical SpecificationsOperator Chassis Parts IdentificationPreparation of the Gate Installing the Gate OperatorBefore mounting the operator, check the following Using the Mounting Template TemplateMounting Mounting the Operator Removing the Operator HousingNot provided Connecting Power to the OperatorRight Mounted Arm Gate Arm Connection OverviewInstall the key into the output shaft. Fig Connecting the Gate Arm to the GateExit Control Board DescriptionOpen Limit Setting Setting the LimitsStall Force Adjustment Stall Force and Auto-Close AdjustmentsDIP #1 Open Direction DIP Switch SettingsInput Connections Siren-Activated Entry Device Accessory Terminal ConnectionsGTO Loop Detector Button Station Lock COM and Lock N.O. / Lock N.C. Lock relay output Output Connections12Vdc @ 300 mA Power Supply Accessory Power Supply ConnectionPrison Mode Operation Class IV Applications Wiring a 3-button stationReinstalling the Operator Housing Dual Gate Link Connection Installing a Dual Gate Operator SystemSlave DIP Switch Settings Setting Dual Gate SequenceSlave Operator Overview of a Dual Gate Operator InstallationMaintenance Schedule MaintenanceGP-SW050 Audible Feedback TroubleShooting GuideCycle LED on brightly Safety LED onShadow LED on Open Edge LED onOpen LED on brightly Close Edge LED onClose LED on brightly Stop LED on brightlyInstructions for the Consumer/End User Warranty and Repair ServiceW . g t o a c c e s s . c o m Installation ChecklistInstallation of this operator conforms to Class