GTO GP-SW050 owner manual Required Safety Precautions for Gates, Entrapment Protection

Page 8

Important Safety Instructions

Required Safety Precautions for Gates

Entrapment Protection

GTO’s internal obstruction settings, even when properly adjusted, may not be sensitive enough to prevent bodily injury. For this reason, safety devices such as safety edges and photo beams MUST be installed. Furthermore, a walk-through gate must be installed if pedestrian traffic is expected near the gate. We recommend the GTO Bulldog Pedestrian Gate Lock (available as an accessory) for controlled access.

Pedestrian Gate	Safety Edge	Warning Sign	Safety Edge
		Warning Sign
		Vehicle Gate
	Safety Edge	Photo Beams
	Safety Edge

Operator

Photo Beams

!WARNING

Warning Signs

The warning signs (with orange panel) must be installed on both sides of the gate.

Moving Gate Can Cause

Injury Or Death

1.KEEP CLEAR! Gate may move at any time.

2.Do not allow children to operate gate or play in gate area.

3.This gate is for vehicles only. Pedestrians must use a separate entrance.

5

Image 8

Contents GP-SW050 Conversion Chart Vehicular gate operator class categoriesTable of Contents Important Safety Instructions for the System Designer Before Installation III. After InstallationMeans of Protection Against Entrapment Important Safety Instructions for the Consumer/End User Required Safety Precautions for Gates Entrapment ProtectionMoving Gate Can Cause Injury Or Death Technical Specifications MotorParts Identification Operator ChassisInstalling the Gate Operator Preparation of the GateUsing the Mounting Template Before mounting the operator, check the followingTemplateMounting Removing the Operator Housing Mounting the OperatorConnecting Power to the Operator Not providedGate Arm Connection Overview Right Mounted ArmConnecting the Gate Arm to the Gate Install the key into the output shaft. FigControl Board Description ExitSetting the Limits Open Limit SettingStall Force and Auto-Close Adjustments Stall Force AdjustmentDIP Switch Settings DIP #1 Open DirectionInput Connections Siren-Activated Entry Device Accessory Terminal ConnectionsGTO Loop Detector Button Station Output Connections Lock COM and Lock N.O. / Lock N.C. Lock relay outputAccessory Power Supply Connection 12Vdc @ 300 mA Power SupplyWiring a 3-button station Prison Mode Operation Class IV ApplicationsReinstalling the Operator Housing Installing a Dual Gate Operator System Dual Gate Link ConnectionSetting Dual Gate Sequence Slave DIP Switch SettingsOverview of a Dual Gate Operator Installation Slave OperatorMaintenance Maintenance ScheduleTroubleShooting Guide GP-SW050 Audible FeedbackSafety LED on Cycle LED on brightlyShadow LED on Open Edge LED onClose Edge LED on Open LED on brightlyClose LED on brightly Stop LED on brightlyWarranty and Repair Service Instructions for the Consumer/End UserW . g t o a c c e s s . c o m Installation ChecklistInstallation of this operator conforms to Class