GTO GP-SW050 owner manual Input Connections

Input Connections

NOTE:

•All control inputs are dry-contact, normally open, inputs except for #8. DO NOT apply external voltage sources to these inputs.

•All inputs are connected with respect to COMMON terminal.

•All inputs have a corresponding LED indicator for diagnostic purposes. All input LED indicators, except for the STOP LED, will be dimly lit when its corresponding input is inactive and brightly lit when it is activated.

1CYCLE: (Typically for use with doorbell button or hardwired key pad)

•Each activation at this input will cycle the operation as follows: ….→ OPEN → STOP → CLOSE → STOP → OPEN → …

2 SAFETY: (Typically for use with photo beam device, loop detector
	1	CYCLE
or other non-contact sensors)
• Activation of this input while the gate is closing will cause the gate to	2	SAFETY
stop and return to the opened position.
• Activation of this input while the gate is opening has no effect (gate	3	SHADOW
will continue to open).		LOOP
• Activation of this input while gate is idle will prevent gate from closing.	4	OPEN EDGE
3 SHADOW: (Typically for use with loop detector device)	5
		CLOSE EDGE
• This input is only monitored when the gate is at the fully open
position. At any other position, activation of this input has no effect on	6	OPEN
gate operation.
• Activation of this input while gate at the fully open position will	7	CLOSE
prevent gate from closing.	8
		STOP
4 OPEN EDGE: (Typically for use with safety edge device)
	9
• Activation of this input while the gate is opening will cause the gate to		COM
stop and reverse direction for approximately 2 seconds.
• Activation of this input while the gate is closing has no effect (gate		COM
will continue to close).
• Activation of this input while gate is idle will prevent gate from opening.		COM

5CLOSE EDGE: (Typically for use with safety edge device)

•Activation of this input while the gate is closing will cause the gate to stop and reverse direction for approximately 2 seconds.

•Activation of this input while the gate is opening has no effect (gate will continue to open).

•Activation of this input while gate is idle will prevent gate from closing.

6OPEN: (Typically for use with exit loop or wand)

•Activation of this input will open the gate if it’s not already at the open position

•Activation of this input while at open limit will restart the auto close time (if enabled).

7CLOSE: (Typically for use with 3-button control station)

•Activation of this input will close the gate if it is idle AND not already at the closed position.

•Activation of this input while gate is opening will stop the gate.

8STOP: (For use with 3-button control station that has ‘NORMALLY CLOSED’ STOP button)

•Activation of this input will stop the gate.

•Jumper ‘W1’ must be cut when using normally closed ‘STOP’ button.

•A normally closed button must be connected to ‘STOP’ and ‘COM’ in order for gate to operate.

9COM: Circuit common (reference for all accessory inputs)

•Three (3) terminals to provide extra common connection point.

20