GE FVR-C9S-2UX Drive Series instruction manual Type FVR C9S-2UX F12 F25 F50

FVR-C9S-2UX

Type (FVR _ _ _ C9S-2UX)			F12		F25	F50	001	002	003	005
Applicable motor output1		[Hp]	1/8		1/4	1/2	1	2	3	5
	Frequency setting		Key operation:			Setting with UP/DOWN keys
			Potentiometer:			Terminal for 1-5K ohm VR is provided
			Analog signal:			0-5 VDC 0-10 VDC
						(input resistance = 22k ohm)
	Display	Run mode	Output frequency is displayed. (3 digit LED)
		Fault mode	Cause of fault is displayed.
		Other	LED comes on with charging voltage applied.
	Acceleration/Deceleration time		0-60s (Variable setting) Acceleration time and deceleration
Control			time can be set independently.
	Voltage frequency characteristics		Setting of maximum frequency/base frequency is variable.
	Restart after momentary power failure		"Automatic restart" setting makes it possible to keep motor
			running and restart drive in case of a momentary power failure.
	High Limiter & Low Limiter		Upper limit and lower limit of frequency can be set.
	Bias setting		Bias setting is possible with respect to analog frequency setting.
	Jump frequency		Three jump points and one jump width can be set.
	Torque boost		Setting variable in 32 steps.
	Starting torque	[%]	150% for 60 seconds
	Braking torque5	[%]	150% 1 min.			100% 1 min.		50% 1 min.	30% 1 min.
Braking	DC brake		Brake starting frequency: 3 Hz (fixed)
			Setting of braking current / braking time is variable.
	Overload		Detects overload current and stops drive.
	Momentary overcurrent		Protects drive In case of ground fault (detects at start) and
			short circuit of output circuit.
	Overvoltage		Detects overvoltage of DC bus and stops drive.
Protection	Overheating of cooling element		Detects abnormal temp. rise of cooling element and stops drive.
	Motor protection		Protects standard 4-pole motor and forced-air cooled motor by
			means of electronic thermal overload relay.
	Alarm protection		Outputs contact signal in case of a trip for protection
			(1c contact capacity: AC250V				0.3A	cos = 0.3)
	Installation location		Indoor at an altitude of 3283 feet (1000m) or less and free of
			dust, corrosive gas and oil mist.
	Ambient temperature		-10 to 50°C
	Ambient humidity		20 -90% RH (There shall be no dew condensation)
Environment	Vibration		19 feet/s2 (5.9m/s2) or less
			Vibration frequency: 5 - 55 Hz
	Storage temperature		-25 to 65°C
	Atmospheric pressure		Operation/storage: min 900 mb (equivalent to 3283 feet (1000m)
			Transport: min 660 mb (equivalent to 10720 feet (3265m)
	Enclosure		IP20
Cooling method				Self-cooling				Forced-air cooling

5) This indicates average braking torque of a single motor. (Value varies according to motor efficiency.)

9