Page 13
TM-1020 Series Progressive Scan Shutter Cameras
2.2.7Power Supplies and Power Cable Setup
2.2.7 (a) Power Supplies
The TM-1020 series camera requires 12V DC power that is obtained through the 12-pin connector located on the rear panel of the camera. JAI, Inc. recommends the following power supplies:
PD-12UU | 100-240V AC/12V DC | 1.2A universal voltage power supply, |
| (No 12-pin connector) | US Plug |
PD-12UUP | PD-12UU with12-pin connector | US plug |
PD-12UE | PD-12UU | European plug |
| (No 12-pin connector) | |
PD-12UEP | PD-12UU with 12-pin connector | European plug |
For users providing power through the 12-pin connector, the PD-12P, PD-12UEP and PD-12UUP power supplies are available with the 12-pin mating connector already attached to the leads from the power supply. The PD-12UU and PD-12UE power supplies can be connected to the JAI, Inc. power cable via a terminal strip or directly.
When wiring the PD-12UU and PD-12UE power supplies directly, please note the following:
•The lead ends must be twisted together and tin-soldered for strength and electrical continuity.
•Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and shorting.
•The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.
•All connections must be properly insulated to prevent shorting.
2.2.7 (b) JAI, Inc. Power Cables
If you are using JAI, Inc. power cables such as the 12P-02S, please refer to the 12-pin connector pin-out diagram in “12-Pin Connector (LVDS/RS-422 version)” on page 6. The cable pin-out diagram is shown in Figure 8 below. The color-coded leads use Gray for Ground and Yellow for +12V.