JAI TM-1020 Attaching the Analog Video Output, 12P-02S Interface Cable Pin# Lead Color Function

Page 14

TM-1020 Series Progressive Scan Shutter Cameras

FIGURE 8. 12P-02S Interface Cable (optional)

		+12 V
	GND (Gray)
Male	Power (Yellow)
	Video Out (Red Coax)		}
	HD In (White Coax)
	VD In (Black Coax)

Monitor

Analog

Frame Grabber

12P-02S Interface Cable

Pin#	Lead Color	Function	Pin#	Lead Color	Function
1	Gray	GND	7	Black coax	VD Input
2	Yellow	+12V DC	8	White coax shield	Strobe out
3	Red coax shield	GND	9	White coax	HD Input
4	Red coax	Video Out	10	Brown	RXD (RS-232)
5	Orange coax shield	GND	11	Blue	Integration
6	Orange coax	VINIT IN	12	Black coax shield	TXD (RS-232)

Note: Make sure that the unused leads are not touching and that there is no possibility that exposed wires could cause the leads to short.

2.2.7 (c) Building Your Own Power Cable

Refer to the 12-pin connector pin-out in Section 2.2.2 (a on page 6. Connect the Ground lead to pin #1, and the +12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient current to properly power the camera.

2.2.7 (d) Attaching the Power Cable to the Connector

The 12-pin connector is keyed and will only fit in one orientation. Follow these directions to properly attach the power cable to the camera connector:

1.Rotate the connector while applying slight pressure until the keyways line up.

2.Press the connector into place until firmly seated.

3.Plug the power cord into the 100V AC socket. This will power the camera up.

2.2.8Attaching the Analog Video Output

When connecting the TM-1020 series to an analog frame grabber or a monitor, use the BNC connector on the rear panel of the camera. The input of the monitor should be balanced for 75Ω termination. Standard RG-59 type coaxial cable should carry a full video signal for up to 500 feet. These monitors are specially modified to accept a 30Hz progressive scan image.

The multi-conductor cable 12P-02S from JAI, Inc. can be used to transmit analog video, power, sync. signals, and serial communication. The mini coaxial leads in JAI, Inc. multi-conductor cables are

designed for short runs of no longer than 100 feet.

Installation