Sanyo VCC-MD400P, VCC-MD500, VCC-MD300P, VCC-MD800P Spectral Sensitivity Characteristics

Page 38

Spectral Sensitivity Characteristics

	1.0
	0.8
Response	0.6
Response
Relative	0.4
Relative
	0.2
	0

Ye

G

Cy

Mg

MD800(P) (Color Mode) MD700(P)

MD600(P) (Color Mode)

MD500(P)

MD400(P) (Color Mode)

	400
	1.0
	1.0
	0.9
	0.8
Response	0.7
	0.6
	0.5
Relative	0.4
Relative	0.3
	0.3
	0.2
	0.1
	0
	0
	400
	1.0

450

500

550

600

650

700

Wave Length [nm]

MD800(P) (Night Mode)

MD600(P) (Night Mode)

MD400(P) (Night Mode)

500

600

700

800

900

1000

Wave Length [nm]

	0.8
Response	0.6
Response
Relative	0.4
Relative

Cy

Ye

G

MD300(P)

0.2

0

400

Mg

450

500

550

600

650

700

Wave Length [nm]

− 37 −

Image 38

Contents Technical Manual VVer Contents VCC-MD800/700/600/500 Series Parts Names and DimensionsDimensions Parts Names and Dimensions VCC-MD400/MD300 SeriesConnection of the Interface Board and Camera Unit Interface Board SpecificationsConnection Input-Output Terminal Descriptions Input-Output Terminal Layout and SpecificationsExternal Synchronous Signals FFC ComplianceCommunications Protocol Communications FormatDuring Query Command Other than ACK During Query Command ACKDuring Settings Command Communications FlowMWB Command List for MD800-500ATW ELS OFF BLC OFFBLC on ELS onOFF AGCAGC ON/OFF SMART1OSD Alarm Alarm OUT OFFAlarm OUT on Line OUT OFF EepromCommand List Query for MD800-500 CS FF− 13 − − 14 − Command List for MD400 − 16 − − 17 − DAY Color Burst on LevelCommand List Query for MD400 ADJ Direct BExample Motion Mask Area Settings Figure Model VCC-MD800/700/600/500/400/300⁃⁃ Status Command 2 Except for MD300 ⁃⁃ Status Command 3 Only MD400⁃ ⁃ Status Command 6 Only MD800/700/600/500 ⁃⁃ Status Command 4 Only MD800/700/600/500⁃⁃ Status Command 5 Only MD800/700/600/500 ⁃⁃ When setting the motion setting to on When unable to set Auto switch setting⁃⁃ When setting Sense UP ⁃⁃ When setting V-RESO UP to on When unable to setModel Code Communications Protocol Zoom Position Control Function DescriptionsZoom Control ⁃⁃ Direct ⁃⁃ Tele/WideFocus Control White Balance ControlAGC Control Iris ControlShutter Speed Control Backlight Compensation Motion Detection 10 Day/Night Switch ControlAperture Details of the Mask Angle and Position Privacy Mask Settings Display Area Ntsc PALSetting the Mask Angle Area Mask Degree Set Area Mask Degree SetSetting the Mask Position Area Mask Position Set Frequency that can be stabilized To clarify the image when using the stabilizerStabilizer Moving Distance Query Command Auto Pursuit FunctionApplication Software Camera Control Command TransmissionCommunications Error RS-232C PortSpectral Sensitivity Characteristics Specifications Ntsc systemPAL system Change history Change history