Sony EVI-D30 Pan/ Tilt Operation, 10EN, To face the camera back to the front

Basic Operations

Pan/ Tilt Operation

1

If you wish to face the camera toward the opposite direction in which the arrow on a pressed button points

The camera is preset to face toward the right

whenever the arrow ( ) button is pressed. You

POWER

SELECT

3

ENTRY

BACK

LIGHT

CAMERA

OFFSET

AUTO

ZOOM

2

DETECT

1

AE

DISPLAY

FOCUS

ON/OFF

AT

FRAME

AUTO

CHASE

FRAME

FAR

MD

START/STOP

3

NEAR

ON/OFF

MANUAL

DATA

SCREEN

REV

2

STD

STD

5

1

4

PRESET

MENU

CAMERA SELECT

			REV
6					2
	RESET
			PAN
-TILT/CURSOR
POSITION			-TILT		PAN-TILT
PAN		HOME	RESET
				FAST	RESET
			ZOOM·
	CURSOR				T
			SLOW·		W
			T

might wish to face the camera toward the opposite direction in which the arrow on a pressed button points, in such a case when you change the direction of the camera while checking the picture on the screen. In this case, press the REV button while holding down the L/R DIRECTION SET button.

To reset that setting, press the STD button while holding down the L/R DIRECTION SET button.

HOME	W	SET
	DIRECTION
	L/R

L/R DIRECTION

SET

1 Press the POWER button.

The camera will be turned on, performing the pan/tilt reset action automatically.

2 Press the arrow button to perform the pan/tilt operation.

While checking the picture on the screen, press a desired arrow button.

To move the camera inch by inch, press the button for a moment.

To move the camera in a wide range,

press and hold down the button.

To move the camera diagonally, press

the arrow button ( or ) while holding

down the arrow button ( or ).

To face the camera back to the front

Press the HOME button.

If you accidentally move the camera with your hand

Press the PAN-TILT RESET button to reset the pan/tilt position.

The deviation from the position that the camera memorizes will be corrected and the operation will be back in order.

Arrow	Movement of	Setting
button	the camera
		While holding
		down
		L/R
		DIRECTION SET
		Press
		STD
		1
		While holding
		down
		L/R
		DIRECTION SET
		Press
		REV
		2

Note

Repeat the above-mentioned procedure for each remote commander if you are using more than one remote commander. This is because the setting is performed by changing the signal emitted from each remote commander, not by changing the setting of the camera itself.

If the lamp at the side of the lens flashes red

The micro computer inside the camera might not memorize the current pan/tilt position properly. Press the PAN-TILT RESET button to reset the pan/tilt position.

Flashes.

10EN