MODE | Tracking method | Intended use |
CHASE 1 The pan/tilt action is | Used to check | |
| not performed. | if the subject is |
| (Camera does not | recognized. |
| move.) The frame |
|
| tracks a subject only in |
|
| the range of the screen. |
|
|
| |
CHASE 2 The frame tracks a | Used to | |
| subject while the pan/ | perform |
| tilt action is performed. | normal |
| In this mode, the | tracking |
| subject is always | operation. |
| placed in the middle of |
|
| the screen.* |
|
|
| |
CHASE 3 Uses the same tracking | Used when | |
| method as that of | you wish to |
| CHASE 1 except that if | limit the |
| a subject almost goes | camera |
| out of the screen, the | movement as |
| camera performs the | possible, in |
| pan/tilt action so that | such a case |
| the subject is placed in | when you |
| the middle of the | perform the |
| screen.* | image |
|
| transmission. |
|
|
|
*The position in which the subject is to be placed can be changed from the middle of the screen. See “Changing the frame position” on page 16.
If the frame is repeatedly extended to the full screen
The camera does not recognize the subject. Press the START/STOP button and go back to the step 2. If doing so does not solve the problem, see “If a subject cannot be recognized or captured” on page 17.
To turn off the setting value and/or frame
If the setting value and/or frame are displayed as you record a picture, those come with the recorded picture.
To turn off the setting value, press the DATA
SCREEN button.
To turn off the frame, press the FRAME DISPLAY button.
Note
Once the setting value is turned off, the setting value is not displayed until the next time you press the DATA SCREEN button. However, the setting value is displayed automatically when the unit enters into the AT setting mode for the first time after the power is turned back on.
To keep the brightness of the subject as is (Auto back lighting function)
After the step 2, press the AE button.
AT MODE |
| |
SETTING |
| ENTRY1 |
| 51 | |
|
|
|
|
|
|
AT AE
CHASE 1
To disactivate the function, press that button
again.
Note
Be sure to press the AE button before proceeding with the step 3. This function is not activated after the START/ STOP button is pressed.
To keep the size of the memorized subject as is
After the step 2, press the AUTO ZOOM button. To cancel the function, press that button again.
To cancel the AT function
Press the START/STOP button.
The information of the memorized subject is erased.
To exit from the AT setting mode, press the
AT ON/OFF button.
If the lamp at the side of the lens light up
The camera is not capturing the memorized subject correctly.
Press the arrow button to perform the pan/tilt operation so that the subject comes into the screen. Or have the subject memorized onto the camera again.
Lights up.
continue to next page 15EN