Millennium Enterprises Integrated Modeling Amplifier manual Gain Exp 1 Min 56Max

Section - 6 The J-12 Foot Controller

Johnson Millennium

Assigning Parameters to Footswitches/ Expression Pedals

The Millennium allows you to control up to 16 Parameters per Preset. Each time you link a parameter to a Footswitch or expression pedal, it is added to any assignments already made to that controller. This is where the Millennium becomes the dedicated work horse that it is, by doing all of the organizing for you so all you have to do is select which parameter is being controlled, then tell the Millennium to “Make it so”.

To assign any currently selected Parameter to a footswitch or Expression pedal in the currently selected bank, do the following:

1.Be sure that the parameter you want to link is displayed and selected (below, is an example the Channel A gain setting) Turning the <1> knob make the Gain in Channel A active for linking. The display should appear something like this:

	a: gain lvl B:Gain LVL
2								￿￿
		40			100%					100￿ %
	1			2			3	70	4
	LINK CHANGED			LINK CHANGED			LINK	CHANGED	LINK CHANGED
			WAH TUBE EQ				GATE
											L/R OUTS
FACTORY USER						#DIGITAL
PAGE 2 OF 5 b
							CLIP				L/R OUTS

2. Turn the <4> knob to select the gain parameter, then press the <Assign> button once. The display reads:

Gain Exp 1 Min[ 56]Max

2

￿￿

On

Pdl

￿100

1

2

3

0

4

LINK CHANGED

LINK CHANGED

LINK

CHANGED

LINK CHANGED

WAH TUBE EQ

GATE

L/R OUTS

FACTORY USER

#DIGITAL

PAGE 1 OF19 b

CLIP

L/R OUTS

3.Select the footswitch or move the expression pedal to be used. An example would be to use Exp 1. From there, use knobs <3> and <4> to set the minimum and maximum ranges of the gain. Minimum and maximum settings can also be set in reverse. An example would be if you set the Gain Min and Max levels in reverse so when the Expression Pedal is moved forward, it would lower the Gain setting.

Once this is done the display will appear something like this:

Gain Exp 2

Min[ 69]Max

2

￿￿

On

Pdl

55

1

2

3

20

4

LINK CHANGED

LINK CHANGED

LINK

CHANGED

LINK CHANGED

WAH TUBE EQ

GATE

L/R OUTS

FACTORY USER

#DIGITAL

BANK

1 OF 19 b

CLIP

L/R OUTS

4.To exit the parameter assignment mode press the <Preset> button to return to Preset mode. The <Store> button will stay bright until these changes are stored, or the preset is changed.

70

User Guide