JVC GR-DV2000 specifications Possible, Snapshot is pressed, Switch is set to

88 EN			INDEX Indications (cont.)
	Indications	Function
	INSERT ERROR!	● Appears if Insert Editing is attempted on a tape recorded in the LP mode.
	<CANNOT EDIT		( pg. 72)
	ON A LP RECORDED	● Appears if INSERT (w) on the remote control is pressed when the erase
	TAPE>
		protection tab is set to “SAVE”.	( pg. 72)
	<CHECK TAPE’S ERASE
		● Appears if the Shooting Mode Switch is set to “XGA/VGA” or “UXGA”.
	PROTECTION TAB>
			( pg. 16)
	<CHECK SHOOTING
	MODE SWITCH>
	MEMORY IS FULL	Appears when the memory card’s memory is full and shooting is not
		possible.

●Appears if dubbing of copyguarded signals is attempted while this camcorder is being used as a recorder.

●Appears in the following cases when dubbing from a tape to a memory

COPYING FAILED	card:
	– when no memory card is loaded.
	– when the memory card's memory is full.
	– when the memory card is not formatted.	( pg. 60)
	– when a copy-protected SD Memory Card is loaded.
	Appears in the following cases if a memory card is not loaded when
	SNAPSHOT is pressed:
MEMORY CARD!	– when the Power Switch is set to “ ” or “ ” and the Shooting Mode
	Switch is set to “XGA/VGA” or “UXGA”.

–when the Shooting Mode Switch is set to “VIDEO” and “CAMERA

	MODE” is set to “DUAL” in the Menu Screen.		( pg. 21, 26)
PLEASE	Appears when there is a problem with a memory card and its memory is
	corrupt, or it has not been initialized. Initialize the memory card .
FORMAT
			( pg. 49)
NO IMAGES STORED	Appears if there is no images stored in the memory card when the Power
	Switch is set to “	” and MEMORY PLAY is pressed.
	Appears when the camcorder takes more than 60 seconds to recognize the
CARD ERROR!	loaded memory card. Remove the memory card once and insert it again.
	Repeat these procedures until no indication appears. If the indication still
	appears, the memory card is corrupted.
CHECK CARD’S WRITE	Appears when you attempt to shoot digital still images while a copy-
PROTECTION SWITCH	protected SD Memory Card is loaded.
E01 — E06	The error indications (E01 — E06) show what type of malfunction has
	occured. When an error indication appears, the camcorder turns off
UNIT IN SAFEGUARD
	automatically. Remove the power supply (battery, etc.) and wait a few
MODE REMOVE AND
	minutes for the indication to clear. When it does, you can resume using the
REATTACH BATTERY
	camcorder. If the indication remains, consult your nearest JVC dealer.