JVC GR-DVL9200 specifications 24 EN, Second Recording Scene

24EN

Recording Start/

Stop Button

Switch

Dissolves during 5- second recording mode

Set “SCENE” to “5SD” in the Menu Screen (☞ pg. 18, 20). “5SD MODE” appears in step 1. Record one 5-second clip, and the image at the end of the clip is stored. If you record the next clip within 5 minutes, the previous scene dissolves as the new scene appears.

•If you turn the power off, the stored image

will be lost.

Record a vacation or an important event in 5-second clips to keep the action moving.

1 Set the Power Switch to “5S” while pressing down the Lock Button located on the switch, then pull out the viewfinder fully or open the LCD monitor fully.

2 Press the Recording Start/Stop Button. The tally lamp lights and beep sounds to indicate the start of recording, and after 5 seconds the camcorder enters Record-Standby mode.

•Even if you press the Recording Start/Stop Button again within 5 seconds after recording starts, Record-Standby mode is not engaged.

•If you press and hold the Recording Start/Stop Button, recording continues until the Recording Start/Stop Button is released.

3 To exit the 5S mode, set the Power Switch to “OFF”, “” or “ ”.

To Take A Snapshot In The 5-Second Recording Mode . . .

.... instead of pressing the Recording Start/Stop Button in

step 2, press SNAP MODE repeatedly until the desired snapshot indicator is displayed, then press SNAPSHOT. The camcorder records a 5-second still (☞ pg. 16). When “SCENE” is set to “ANIM.”

(☞ pg. 18, 20) this function is not available.

NOTES:

●When “SCENE” is set to “ANIM.” in the Menu Screen the 5-second recording mode is not available. Anima-

tion recording of a 1/3-second clip is taken instead (☞ pg. 18, 20).

●While the 5-second recording mode is activated, Fade/ Wipe effects (☞ pg. 26) and Program AE with special effects (☞ pg. 25) cannot be performed. However,

when “SCENE” is set to “5SD” in the Menu Screen (☞ pg. 20), the Dissolve function is available.