28EN
RECORDING
Focusing
AdvancedFeatures(cont.)
Focus detection zone
NOTES:
●If the lens is smeared or blurred, accurate focusing is not possible. Keep the lens clean, wiping with a piece of soft cloth if it gets dirty. When condensation occurs, wipe with a soft cloth or wait for it to dry naturally.
●When shooting a subject close to the lens, zoom out first (☞ pg. 14). If
subject. This will not occur when “TELE MACRO” (☞ pg. 20) is activated.
AUTO FOCUS
The camcorder’s Full Range AF system offers continuous shooting ability from
•When two subjects overlap in the same scene. •When illumination is low.*
•When the subject has no contrast (difference in bright- ness and darkness), such as a flat,
•When a dark object is barely visible in the viewfinder.* •When the scene contains minute patterns or identical
patterns that are regularly repeated.
•When the scene is affected by sunbeams or light reflecting off the surface of a body of water.
•When shooting a scene with a
*The following
, , and
MENU/BRIGHT
Dial
Power Switch
FOCUS | FOCUS |
While focusing on a | While focusing on a |
further subject | nearer subject |
NOTES:
●When the power is turned off, Manual Focus will be reset to “AUTO”.
●Be sure to focus the lens in the maximum telephoto position when you use the Manual Focus mode. If you focus in on a subject in the
●When the focus level cannot be adjusted any further or closer, “” or “” will blink.
MANUAL FOCUS
If you are using the viewfinder, you should already have made the necessary viewfinder adjustments ( ☞ pg. 11).
1 Set the Power Switch to “ ” or “5S” while pressing down the Lock Button located on the switch, then pull out the viewfinder fully or open the LCD monitor fully.
2
3 Rotate MENU/BRIGHT to select “ ”, then press it.
4 Rotate MENU/BRIGHT to select “MANUAL” and press it. The Menu Screen disappears and “FOCUS” is displayed. The focus is locked at this point.
5 To focus on a farther subject, rotate MENU/BRIGHT towards “+”. “” appears and blinks.
To focus on a nearer subject, rotate MENU/BRIGHT towards
6 Press MENU/BRIGHT. Focus adjustment is complete. The “FOCUS” indication changes to “MANUAL”.
To Return To Auto Focus . . .
.... select “AUTO” in step 4. Or, set the Power Switch to
“”.