JVC GY-DV5001 manual Error Code Error Details GY-DV5000 Operation Remedy, Tally lamp

13. OTHERS

●Warning Indications for VCR Abnormalities

Should malfunctions occur during VCR operation, the unit self-diagnoses the cause and shows the diagnose together with an error code on the LCD monitor or in the viewfinder.

Error code

*1 If the unit is used in a state where the cassette cover is open after inserting a cassette tape, there can be a case where an error code “3200, 7202, 7302” appears.

WARNING7001

DRUM MOTOR FAILURE

Warning

In such a case, switch off the power once and switch it on again, and then close the cassette cover before use.

Error Code	Error Details		GY-DV5000 Operation	Remedy
0201	Indicates dew formation		Operation stops. All operations	Leave the unit with the power ON,
CONDENSATION ON DRUM	(condensation)		are rejected.	until the indication disappears.
3200	Tape cannot be loaded.			Switch the power OFF and then
LOADING FAILURE		*1		switch it back ON. However, the
				tape may be damaged depending
3300	Tape cannot be unloaded.			on the circumstances. Please
UNLOADING FAILURE				consult the person in charge of
				professional video equipment at
4100	Irregularity with eject			your nearest JVC-authorized
CASSETTE EJECT FAILURE	operation.			service agent.
TAPE DEFECTIVE	Tape is cut.		Operation stops.	Press the EJECT button to take
5605 ~ 5609				out the cassette.
5702	Tape end sensor error.		Operation stops. All operations	Switch the power OFF and then
TAPE END DET. ERROR			are rejected.	switch it back ON. However, the
				tape may be damaged depending
5802	Tape beginning sensor			on the circumstances. Please
TAPE BEGIN DET. ERROR	error.			consult the person in charge of
				professional video equipment at
7001	Drum rotation error.
				your nearest JVC-authorized
DRUM MOTOR FAILURE				service agent.
7101	Capstan rotation error.
CAP MOTOR FAILURE
7202 ~ 7203	Supply reel rotation
SUPPLY REEL FAILURE	error.	*1
7302 ~ 7303	Take up reel rotation
TAKE UP REEL FAILURE	error.	*1
7305	Irregular tape winding
TAKE UP REEL FAILURE	when unloading.
7401	Reel motor rotation error.
REEL MOTOR FAILURE
TURN POWER OFF.	System error when power		MODE indicator and TALLY	Turn off the power and let the unit
TURN BACK ON LATER.	is turned on.		lamp flash. Only Power switch	sit for sometime before turning it
			operation is accepted.	back on.

■TALLY lamp

Blinks when remaining battery power or tape is low. (Only in Camera mode)

Blinking Pattern	Remaining Battery/Tape
Slow blinking	● Remaining battery power is low.
(once per sec.)	● Remaining tape time is equivalent to less than 3 minutes.
Fast blinking	● Tape has run out.
(four times per sec.)	● Irregularity has occurred in the VCR.

E-91