JVC LYT0844-001A specifications EN83

		EN83
SYMPTOM	POSSIBLE CAUSES	CORRECTIVE ACTION
42. The LCD monitor, the	42.	42. • Wipe them gently with soft
viewfinder and the lens have	————	cloth. Wiping strongly can
become dirty		cause damage ( pg. 84).
(ex. fingerprints).
43. An unusual mark appears.	43.	43. • Check the section of the
	————	manual that explains LCD
		monitor/viewfinder indica-
		tions ( pg. 88 – 92).
44. An error indication	44. • A malfunction of some kind	44. • Remove the power supply
(E01 — E06) appears.	has occurred. In this case the	(battery pack, etc.) and wait a
	camcorder’s functions	few minutes for the indication
	become unusable.	to clear. When it does, you
		can resume using the
		camcorder.
		If the indication remains even
		though you repeat the above
		two or three times, please
		consult your nearest JVC
		dealer.
45. The charger indicator on the	45. • The temperature of the battery	45. • To protect the battery, it is
AC Power Adapter/Charger	is extremely high/low.	recommended to charge it in
does not light.	• Charging is difficult in places	places with a temperature of
	subject to extremely high/low	10°C to 35°C ( pg. 93).
	temperatures.
46. Picture does not appear on	46. • The viewfinder is pulled out.	46. • Push the viewfinder back in.
the LCD monitor.	• The LCD monitor's brightness	• Adjust the brightness of the
	setting is too dark.	LCD monitor ( pg. 20).
		• If the monitor is tilted upward
		180 degrees, open the
		monitor fully ( pg. 20).
47. When the image is printed	47. • This is not a malfunction.	47. • By recording with “DIS”
from the printer, a black bar		activated ( pg. 41) this can
appears at the bottom of the		be avoided.
screen.
48. When the camcorder is	48. • The DV cable was plugged/	48. • Turn the camcorder’s power
connected via the DV	unplugged with power turned	off and on again, then operate
connector, the camcorder	on.	it.
does not operate.
49. The memory card cannot be	49.	49. • Push in the memory card a
removed from the	————	few more times ( pg. 16).
camcorder.