| EDITING EN 41 | |
Dubbing To Or From A Video Unit | To use this camcorder as a player | |
1 Make sure all units are turned off. | ||
Equipped With A DV Connector (Digital | ||
2 Connect this camcorder to a video unit equipped with | ||
Dubbing) | a DV input connector using a DV cable as shown in the | |
| ||
| illustration. | |
It is also possible to copy recorded scenes from the | 3 Start playback on the camcorder. ( pg. 19) | |
camcorder onto another video unit equipped with a DV | 4 At the point you want to start dubbing, start recording | |
connector. Since a digital signal is sent, there is little if | ||
on the video unit. (Refer to the video unit’s instruction | ||
any image or sound deterioration. | ||
manual.) | ||
| ||
| 5 To stop dubbing, stop recording on the video unit, then | |
| stop playback on this camcorder. |
NOTES:
Core filter 
To DV IN/OUT
DV cable (optional)
●It is recommended to use the AC Adapter as the power supply instead of the battery pack. ( pg. 13)
●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.
●Even though the DV cable is connected correctly, sometimes the image may not appear in step 4. If this occurs, turn off the power and make connections again.
●If “Playback Zoom” ( pg. 22) or “Playback Special Effects” ( pg. 22) is attempted or SNAPSHOT is pressed during playback, only the original playback image recorded on the tape is output from the DV IN/OUT connector.
●When using a DV cable, be sure to use the optional JVC
To use this camcorder as a recorder
1 Make sure all units are turned off.
2 Connect this camcorder to a video unit equipped with a DV output connector using a DV cable as shown in the illustration.
To DV IN/OUT
Video unit equipped with DV connector
3 Set “REC MODE” to “SP” or “LP”. ( pg. 29)
4 Set the camcorder’s Power Switch to “PLAY”.
5 Press the Recording Start/Stop Button to engage the
●The “ DV. IN ” indication appears on the screen.
6 Start playback on the player.
7 At the point you want to start dubbing, press the Recording Start/Stop Button to start dubbing. The 
indication rotates.
8 Press the Recording Start/Stop Button again to stop
dubbing. The 
indication stops rotating.
9 Press 8 to return to the normal playback mode.
NOTES:
●If no image is displayed on the LCD monitor, set “S/AV INPUT” to “OFF”. ( pg. 29, 32)
●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting. ( pg. 30)
ADVANCED FEATURES