Panasonic AG-DVC 200E manual Attaching the lens, Raise the lens lever, and remove the mount cap

Preparation

Using an AC power supply (with the AJ-B75 AC adapter)

1 Connect the unit’s external DC input socket with the DC OUT socket on the AJ- B75 AC adapter.

External DC input socket

AC adapter

≥AJ-B75 (optional accessory)

2 Turn on the AC adapter’s power.

3 Set the unit’s POWER switch to ON.

When an AC adapter other than the AJ-B75 is to be used, check the pin signals of the external DC input socket.

Attaching the lens

1 Raise the lens lever, and remove the mount cap.

Lens lever

Mount cap

2 Fit the centre mark on the lens into the centre cutout on the top of the lens mount, and attach the lens.

Mark

3 Pulllens. down the lens lever to secure the

ENGLISH

1 4

2 3

External DC input socket

Pin No	Signal
1	GND
2, 3	–
4	+12 V

<Notes>

≥When both a battery pack and an AC adapter have been connected, the power supplied from the AC adapter takes priority. It is also possible to attach/remove a battery while the AC adapter is being used.

≥When an AC adapter is to be used, the unit’s POWER switch must be set to ON only after the AC adapter’s power has been turned on. If the power is switched on in the reverse sequence, the AC adapter’s output voltage will rise slowly, possibly causing the unit to malfunction.

4 Push the cable into the cable clamp, and connect it to the LENS jack.

LENS jack

5 Proceed with the flange back adjustment for the lens.

<Notes>

≥For details on how to handle the lens, refer to the operating instructions of the lens.

≥While the lens is removed, attach the mount cap to protect the unit.

12 (E)