![](/images/new-backgrounds/1242408/24240845x1.webp)
Time data settings
When both the user’s bit and time code are to be used, the user’s bit is set first. The time code can be set from 00:00:00:00 to 23:59:59:29.
ENGLISH
Setting the user’s bit
By setting the user’s bit, memos (date, time) and other information consisting of up to 8 hexadecimal digits can be recorded on the
1 Set the COUNTER/TC/UB switch to UB.
2 Set the TCG switch to SET.
“UBG ¢¢:¢¢:¢¢:¢¢” now appears in the viewfinder. Select a number for the flashing part by rotating the JOG dial button, and press the JOG dial button to enter it. When the number is entered, the flashing moves to the next character on the right so that another number can be input in the same way until the user’s bit is set.
3 Set the TCG switch to
4 Select the “UB MODE” on the
Concerning the user’s bit memory function
The user’s bit settings (except for the actual time) are automatically stored in the memory and retained even after the power has been turned off.
<Notes>
≥When DATE is selected for “UB MODE” on the
≥When TIME is selected for “UB MODE” on the
Setting the time code
1 Set the COUNTER/TC/UB switch to TC.
2 Set the TCG switch to SET.
“TCG ¢¢:¢¢:¢¢:¢¢” now appears in the viewfinder. Set the time code by performing the same operations used to set the user’s bit.
3 Set the TCG switch.
Set this to
<Note>
The backup accuracy of the time code will be out by several frames when the POWER switch has been set from ON to OFF and then back to ON again.
22 (E)