Axis Communications P3354 user manual Storage, Bonjour, SD Card, Network Share

Page 43

AXIS P3354 Network Camera

System Options

Bonjour

The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating systems and clients that support this protocol.

Bonjour can be disabled under System Options > Network > Bonjour.

Storage

SD Card

The Axis product supports SD cards with up to 64 GB of storage. For best recording performance, use an SDHC or SDXC card with speed class 10.

NOTICE

To prevent corruption of recordings, the SD card should always be unmounted before it is ejected.

The Axis product supports SD cards with the following file systems:

•ext4 — recommended due to its resilience against data loss if the card is ejected or if there is abrupt power loss. To access data stored on the card from the Windows operating system, a third-party ext4 driver or application is required.

•vFAT — supported by most operating systems for personal computers.

If required, the SD card can be manually formatted to the desired file system. To format the SD card:

1.Insert the SD card in the SD card slot.

2.Go to System Options > Storage and click SD Card.

3.Click Format and select the desired file system.

Note

During formatting any previous data stored on the disk will be lost.

Mounting is done automatically when the card is inserted or when the product is started. A manual mount is only required if the card has been unmounted and not ejected and re-inserted.

To unmount the SD card:

1.Go to System Options > Storage and click SD Card.

2.Click Unmount.

3.The card can now be removed.

The SD card is managed on the System Options > Storage page. Click SD Card to open Storage Management.

If the card’s status shows as failed, click Check disk to see if the problem can be found and then try Repair. This option is only available for SD cards with ext4. For SD cards with vFAT, use a card reader or computer to troubleshoot the card.

To avoid filling the card, it is recommended to remove recordings continuously. Under Recording Settings, select Remove recordings older than and select the number of days or weeks.

To stop writing to the card and protect recordings from being removed, select Lock under Recording Settings.

Network Share

Network share allows you to add network storage such as a NAS (network-attached storage). The NAS shall be dedicated for recordings and data from the Axis products connected to the network. For information about reference NAS devices, go to www.axis.com/products/cam_companion_software/supported.htm

43

Page 42 Page 44
Image 43
Page 42 Page 44
Contents Axis P3354 Network Camera Intellectual Property Rights About this DocumentLegal Considerations LiabilityLearn More SupportAxis P3354 Network Camera Table of ContentsHardware Overview Connectors and ButtonsNetwork Connector For technical specifications, seeSD Card Slot LED IndicatorsColor Indication Start a browser Internet Explorer, Firefox, Safari Accessing the ProductAccessing the Product Access from a BrowserClick Create self-signed certificate Accessing the Product Access from the InternetSet the Root Password Set Power Line FrequencyControls on the Live View Live ViewAxis Media Control viewer toolbar PTZ Controls Axis Media Control AMC How to Stream H.264Media Streams Media StreamsQuickTimeTM. The following paths can be used Alternative Methods of Accessing the Video StreamAxis P3354 Network Camera Setting Up the Product Setting Up the ProductBasic Setup Image Setting Up the Product VideoClick Save to apply the new settings Video StreamStream Profiles Camera Settings264 Wide Dynamic Range Exposure SettingsImage Appearance White BalanceGo to Video View Area Iris adjustmentView Area Day/NightGo to Video Video Stream and select the Image tab Select an Aspect ratio and a Video stream resolutionOverlay Overlay ImageGo to Video Video Stream and select the Image tab When satisfied, click Enable iris to enable the irisPrivacy Mask Focus & ZoomAxis P3354 Network Camera Viewer Settings Live View ConfigLive View Config Default Viewer for BrowsersUser Defined Links Guard Tour Preset PositionsPTZ Pan Tilt Zoom PTZ Pan Tilt ZoomControls Operator Same as administrator but with lower priorityPTZ Pan Tilt Zoom Advanced Control QueueMotion Detection DetectorsDetectors Camera TamperingMotion Detection Parameters Set Up Motion Detection WindowsAxis P3354 Network Camera Application Licenses Install ApplicationApplications ApplicationsAxis P3354 Network Camera Events EventsPTZ Control Setting Up an Action RuleSystem TimeGo to Events Recipients and click Add RecipientsSchedules Recipient Use with actionGo to Events Recurrences and click Add RecurrencesTo create a new schedule Go to Events Schedules and click AddContinuous Recording RecordingsRecordings Recording ListUsers System OptionsSystem Options SecurityCertificates IeeeGo to System Options Security Ieee Network Basic TCP/IP SettingsGo to Setup System Options Security Certificates Date & TimeARP/Ping IPv4 Address ConfigurationIPv6 Address Configuration Axis Internet Dynamic DNS ServiceHost Name Configuration Advanced TCP/IP SettingsDNS Configuration NTP ConfigurationFTP NAT traversal port mapping for IPv4RTP/H.264 QoS Quality of ServiceUPnPTM can be disabled under System Options Network UPnPTM UPnPTMNetwork Share StorageBonjour SD CardTo add a network share MaintenanceGo to System Options Storage Click Network Share Logs & Reports System Options SupportSupport Overview System OverviewPlain Config Reset to Factory Default SettingsFile Upload Checking the Firmware TroubleshootingTroubleshooting Emergency Recovery ProcedureProblems setting the IP address Symptoms, Possible Causes and Remedial ActionsProduct cannot be accessed from a browser Problems with streaming H.264 Product is accessible locally but not externallyBasic Storage and disk management problems Status and Network indicator LEDs are flashing red rapidlyVideo and image problems, general Video Camera SettingsTechnical Specifications Technical SpecificationsMaintenance General Casing Function/group Specifications Network SecurityAlarm actions InstallationPerformance Considerations ConnectorsM3.4

P3354 specifications

Axis Communications P3354 is a high-performance network camera designed to meet the demands of modern security and surveillance applications. Engineered with advanced imaging technologies, this camera offers exceptional video quality, reliability, and versatility for various environments.

One of the key features of the P3354 is its high-resolution video capabilities. With a 2 MP sensor, the camera delivers crisp images at resolutions up to 1080p. This ensures clear and detailed video footage, making it suitable for identifying faces or reading license plates in security-critical applications. The camera supports multiple streaming formats, allowing users to select the appropriate compression and resolution for their specific needs.

The P3354 is built with Axis’ proprietary Wide Dynamic Range (WDR) technology, which enhances image quality in challenging lighting conditions. This is particularly useful in outdoor settings where there can be a significant contrast between light and dark areas. The camera can capture details in both bright highlights and dark shadows, ensuring comprehensive coverage of a scene.

Additionally, the P3354 features Lightfinder technology, which is designed to optimize performance in low-light environments. This innovative technology utilizes a sensitivity-enhancing mechanism that allows the camera to produce color images even in very low light, making it an ideal solution for nighttime security.

The camera's robust design is built to withstand environmental challenges. It comes with an IP66 rating, ensuring that it is dust-tight and can withstand heavy rain, making it suitable for both indoor and outdoor use. The P3354 is also equipped with a tamper-resistant casing to deter vandalism and unauthorized access.

Axis’ application platform enables users to integrate the P3354 with various video management systems and smart analytics features. The camera supports features such as motion detection, audio detection, and tampering alarm, ensuring proactive security monitoring.

Installation and configuration are user-friendly, thanks to the camera's Power over Ethernet (PoE) capability, which simplifies wiring requirements. The P3354 can be easily mounted on walls or ceilings, providing flexible placement options to meet surveillance needs.

In summary, the Axis Communications P3354 is a versatile network camera that combines high-resolution imaging, advanced technologies like WDR and Lightfinder, along with a durable design suited for various environmental conditions. With these features, the P3354 stands as a reliable choice for comprehensive surveillance and security applications.
Top Page Image Contents