FlexiDome2X | Installation en 19 |
|
|
3.3.3Surface mounting
When using the surface mounting box:
–With a side connection, remove the cap covering the side entrance.
With a rear connection, leave the cap in place.
–Attach the conduit to the mounting box.
–Release the two clips at the bottom of the watertight connection compartment to remove it from the mounting box.
–Open the cover of the watertight compartment in the mounting box by releasing the five clips.
–Run the power and video cables through separate rubber grommets into the watertight compartment.
–Run the cable from the camera into the watertight compartment through the supplied grommet.
–Make the connection inside the watertight compartment and clip on the cover to seal it.
Figure 3.5 Surface mounting box VDA-455SMB
Note:
To ensure a watertight cable entry, use round cables of between 5 and 6 mm (0.2 - 0.24 inches) for power and video connection.
Note:
Use some silicon spray on the cable to help slide the grommets onto it.
Bosch Security Systems | Installation Manual |