FlexiDome2X | Connection and |
|
|
4.2Setting up the camera
4.2.1Camera positioning
CAUTION!
The Heater will be hot when in operation - Do not touch.
! Always switch the heater off when working on the camera, refer to Section 4.2.4 Heater, Page 26 and Section 5.6.2 Connections submenu, Page 42.
To assist in setting up the camera, connect a monitor to the miniature 2.5 mm jack socket (2). This socket provides a composite video signal (with sync). An optional cable (code number S1460) is available for making this connection. When the S1460 cable is attached, there is no video available on the BNC connector to avoid interference.
A
C
B
Figure 4.1 Camera parts
1.Heater
2.Monitor jack socket
3.Thumbwheels
Bosch Security Systems | Installation Manual |