Cleaning Cleaning, Electronic Zoom EL-ZOOM

CNT-CLS 1, 2 (Output)

Two contact closure signals (Open collector type) are output through the Alarm Output connector.

1.Move the cursor to CNT-CLS 1, and select OFF, ALARM or AUX 1 with the joystick.

The factory default setting is OFF.

When ALARM is selected, TIME OUT appears. Select an appropriate duration from among 100 MS, 200 MS, 1000 MS (1 s), 2000 MS (2 s) and 4000 MS (4 s) with the joystick.

The factory default setting is 100 MS.

Note: The shorter the duration, the more frequent will be the detection output.

2.Move the cursor to CNT-CLS 2, then select OFF, B/W or AUX 2 with the joystick.

The factory default setting is OFF.

OFF: Contact closure signals are deactivated.

ALARM: Available for CNT-CLS 1 only. A motion detection signal is output.

AUX 1(2): An alarm signal is output when the cam- era receives a command from the controller.

B/W: Available for CNT-CLS 2 only. ON (active) is output when the camera operates in the black and white mode if ALARM IN 4 is set to B/W.

Note: It is recommended to set the connected exter- nal device to ignore the shorter alarm outputs of 90 ms or less from the camera.

COAXIAL ALARM OUT

Alarm output signals are supplied through the coaxial cable.

1.Move the cursor to COAX ALM OUT and select ON or OFF.

2.Press the CAM (SET) key.

The factory default setting is OFF.

ON: The camera sends an alarm output signal after it turns to a preset position.

OFF: The camera does not send an output signal.

Notes:

•The camera ignores alarm inputs during manual operation.

•Select OFF when the camera downloads or uploads the preset data.

●Cleaning (CLEANING)

With CLEANING in the ON position, the camera’s built- in electro-mechanical contacts are cleaned at regular intervals (approx. every 7 days).

A dry contact adversely affects picture quality and motors operation.

1.Move the cursor to CLEANING and select ON or OFF with the joystick.

** SPECIAL	1 **
PRIVACY ZONE	OFF
PROPO.P/T	ON
AREA TITLE	ON(USER)
PATROL	STOP
ALARM IN/OUT
CLEANING	ON
EL-ZOOM	ON
PRESET ALM	OFF
IMAGE HOLD	OFF
TILT ANGLE	0°
RET

ON: The contacts are cleaned for approx. 1 minute. "CLEANING" disappears when the cleaning process is completed.

CLEANING

OFF: No contact cleaning.

Note: Select OFF when the camera downloads or uploads the preset data.

●Electronic Zoom (EL-ZOOM)

The electronic zoom magnifies a scene 10-fold. With a 22-fold optical zoom lens, the camera is capable of 220-fold zoom.

1.Move the cursor to EL-ZOOM and select ON or OFF with the joystick, and then press the CAM (SET) key.

** SPECIAL	1 **
PRIVACY ZONE	OFF
PROPO.P/T	ON
AREA TITLE	ON(USER)
PATROL	STOP
ALARM IN/OUT
CLEANING	ON
EL-ZOOM	ON
PRESET ALM	OFF
IMAGE HOLD	OFF
TILT ANGLE	0°
RET

-32-