●Motion Detector (MOTION DET)
1.Move the cursor to MOTION DET and select ON or OFF with the joystick.
** SET UP **
CAMERA ID | OFF | ||
ALC/MANUAL | ALC | ||
SHUTTER |
| AUTO | |
AGC |
| ON(MID) | |
SENS UP |
| OFF | |
SYNC |
| INT | |
WHITE BAL | ATW1 | ||
MOTION DET | ON |
| |
AF MODE |
| AUTO L | |
RET | SPECIAL2 | ||
2.If ON is selected, press the CAM (SET) key. The MOTION DETECT menu appears.
You can mask the areas in this menu.
3.Move the cursor to MASK SET and press the CAM (SET) key. 48 mask areas appear on the monitor screen.
Refer to Light Control Setting on page 35 for mask- ing operations.
4.After masking areas, press the MON (ESC) key. The MOTION DETECT menu appears on the monitor screen.
5.Move the cursor to ALARM and select ON or OFF with the joystick.
ON: The alarm signal is supplied while the display mode is activated.
OFF: The alarm signal is not supplied while the dis- play mode is activated.
6.Move the cursor to DISPLAY MODE.
Press the CAM (SET) key to see the present setting. The areas that detect the motions blink.
7.Move the cursor to LEVEL with the joystick.
Obtain the optimum detection level with the joystick.
** MOTION DETECT **
LEVEL | •••••••• |
| |
| - | + | |
DWELL TIME |
| 2S | |
DISPLAY MODE |
|
|
|
ALARM |
| OFF | |
MASK SET |
|
|
|
RECOVER TIME |
| 1MIN | |
RET |
|
|
|
Note: Repeat the above procedure until you obtain the adjusted results.
8.Dwell Time
Move the cursor to DWELL TIME, and select a time with the Joystick.
When the time specified here elapses after motion detection, the camera will notify the connected device of the alarm activation. The default setting is 2 seconds.
Selectable times (seconds): 2s, 5s, 10s, 30s
9.Move the cursor to RECOVER TIME with the joystick. You can select the following recover times.
1MIN 
2MIN
3MIN 
5MIN 
10MIN
OFF 
60MIN 
30MIN
20MIN 
10.Move the cursor to RET and press the CAM (SET) key to return to SET UP.
Important Notices:
•The motion detection should meet the following con- ditions.
1)The picture size on the screen should be larger than 1/48 of the actual picture size.
2)The contrast ratio between the object and the background picture should be more than 5 % at the maximum detection level.
3)The time that takes the object to move from one end of the screen to the other should be more than 0.1 second.
•Also under the following conditions, mask or adjust the detection level to prevent malfunction.
1)When leaves, curtains, etc. are swayed by the wind.
2)When a picture has a high noise content due to low light conditions.
3)When the object is illuminated by lighting equip- ment that constantly turns on and off.