AXIS 206/206M Quick Installation Guide
One-click Installation
Page 5
Requirements:
Computer on a LAN
AXIS 206/206M
Broadband router/modem providing automatic IP addressing
Internet
The AXIS Internet Dynamic DNS Service
•The
•Please note that this procedure will send the AXIS 206/206M’s IP address, firmware version, product type and serial number to the Axis Internet Dynamic DNS Service. No personal information is transferred.
•To remove the DNS name and unregister from the Axis Internet Dynamic DNS Service, open the Setup pages in the AXIS 206/206M, click System Options > Network > TCP/IP, click the Settings button for the AXIS Internet Dynamic DNS Service and finally, click the Remove button.
Follow these instructions:
1.Once the network and power cables have been connected, wait for the Status indicator to show a steady green.
2.Now press the Control button on the rear of the camera once. The Status indicator on the front of the camera will blink green while it connects to the AXIS Internet Dynamic DNS Service.
3.Wait for the Status indicator to go back to showing a steady green.
4.To complete the installation, now visit www.axiscam.net from an Internet connected PC. This must be done within 60 minutes of pressing the Control button.
5.Follow the
6.Please see page 7 for instructions on how to set the language and the password.
Notes:
• You will need the camera’s serial number (S/N) to perform the installation. This is found on the label on the rear panel. See page 3.
7.• If this installation was unsuccessful, try one of the other methods described on the following pages.