AXIS 206/206M Quick Installation Guide | Page 7 |
Manual Installation with ARP/Ping
1.Acquire an unused IP address for the AXIS 206/206M. This IP address must be on the same subnet as your computer.
2.Locate the serial number (S/N) on the camera’s rear label.
3.From a computer on your network, open a Command Prompt (in Windows: from the Start menu, select Run... and type cmd in the field. Click OK).
4.As appropriate for your operating system, enter the following commands:
Windows syntax: | Windows | example: |
|
| |
arp | arp | |
ping | ping | 408 |
|
| |
UNIX/Linux/Mac syntax: | UNIX/Linux/Mac example: | |
|
| |
arp | arp | |
ping | ping | 408 192.168.0.125 |
|
|
|
5.Check that the network cable is connected. Start/restart the camera by disconnecting and reconnecting the power cable.
6.Close the Command prompt when you see ‘Reply from 192.168.0.125: ...’
7.The IP address has been set when the Power indicator is permanently lit and the Network indicator flashes intermittently.
8.Start your browser, enter the IP address of the camera in the Location/Address field and press Enter on your keyboard. See below for further instructions.
Note:
After installation, the
Set the language and password
When accessing the AXIS 206/206M for the first time, the language can be changed and the “root” password must be configured.
1.Select the language from the available options, by clicking the appropriate flag.
2.Now enter a password and then
3.The ‘Enter Network Password’ dialog will appear. Enter the user name: root
Note: The default administrator user name root is permanent and cannot be deleted.