Asante Technologies Voyager II user manual

Page 64

Click Browse… to select the location where the firmware file is stored.

4.Click submit.

5.The auto upgrade runs.

The Upgrade Status shows the progress of the upgrade.

When the firmware upgrade has been completed, the machine reboots automatically. Reconnect to the server after 60 seconds.

Note: The new firmware is burned into the Flash ROM during the upgrade, so you must take care during the process and make sure it is not interrupted during the operation. The system may be damaged seriously and need to be returned to the factory for repair if the power cable is removed or becomes loose during the upgrade. Firmware upgrading in wireless network environment is not recommended because unstable packet transmission may bring about loss of data.

When the firmware upgrade has been completed, you don't need to restart the camera manually. The camera will reboot automatically after 60 seconds (Reboot OK). Then open the IE browser and key in the IP address (The original IP address remains undeleted).

64

Image 64
Contents Voyager Ddns Packaging Contents System requirements LANIntroduction System Instructions Fixed on a wall Fig Fixed on a ceiling Fig MIC in/Audio Out Focus knob Hardware Installation Camera Setting MAC Factory default network identity of the machine Camera Setting from a Router Change the Internet Explorer Setting Enter the Main Setup prompt screen Camera Main DescriptionsControl panel Preset presets the rotation points for the camera 16 points Page Ato Selects a language Select an image size Select a video stream protocol Recording button Snapshot button Click the Path field to Select the folder to save File Basic Setting System settingBasic Setting System System info Basic Setting Video/Image Basic Setting Video Image Video ImageAdd a new link Video stream screen Select a video streaming format Select a FPS Basic Setting Video Image OSD Page Basic Setting Audio Sound Basic Setting Audio Audio sound settingBasic Setting UserUser Basic Setting User User List access privilege listBasic Setting User User Setting privilege setting Basic Setting Network Network setting Basic Setting Network Network wired network settingBasic Setting Network Wireless wireless network setting Page Network authentication type Encryption options HEX Basic Setting Network Streaming steaming setting Basic Setting Network PPPoE dial-up networking setting PPPoE setting Ddns setting Basic Setting Network UPnP Universal Plug and Play Open Windows firewall option Basic Setting Network Smtp Server mail server setting Basic Setting Network Samba Page Notification setting Basic Setting Date/Time date/time setting Basic Setting IP Filter Basic Setting IP Filter GeneralApplication Setting Event event trigger setting Application SettingApplication Setting Event Event List trigger event setting Add Event Add Event setting Page Page Add FTP setting Add Http setting Add TCP setting Application Setting Motion Detection Application Setting Firmware upgrade Page Application Setting Factory Default Resets all parametersFile backup Application Setting Reboot Attachment a External Alarm External Alarm I/O Circuit Diagram Image Resolution Average range of Data Sizes Attachment B Bandwidth EstimationAttachment C Troubleshooting and FAQs Question Answer and SolutionAccess to Camera FTP Camera Image Quality