Samsung SCC-C7453N Auto SET, Auto Pan Setup, You can set the Auto PAN, PATTERN, and Auto Play

Page 39

M

The preset position can be specified for a tilt range of between 0° and 90°.

 

Those presets that are out of a tilt of 90° can not be specified.

 

If you try to specify a preset position for a range exceeding a tilt of 90° using a

 

controller (SSC-1000, 2000 or 5000), you will see a message of <SET AGAIN> on

 

the screen. If this is the case, try again for a range below a tilt of 90°.

 

If you upload/download the menu setting using SSC-1000, 2000 or 5000, the preset

 

may differ from the menu setting so define the preset again after the operation.

AUTO SET

You can set the AUTO PAN, PATTERN, and AUTO PLAY.

M

If you upload/download the menu setting using SSC-1000, 2000 or 5000, the

 

settings for AUTO PAN, PATTERN, SCAN, and PRESET may differ from the menu

 

settings so define them again after the operation.

Auto Pan Setup

Set the starting and ending positions to patrol between points at specified speed.

For selecting and saving each menu item, refer to “How to use the keyboard controller”. (page 22)

1. Select <MAIN MENU>-<AUTO SET>.

 MAIN MENU 

PROFILE

CAMERA SET

INTELLIGENCE PRIVACY ZONE PRESET AUTO SET ZONE SET ALARM SET CLOCK SET OTHER SET

English

2.Select the number of <AUTO PAN>. AUTO PAN setup screen appears.

AUTO SET

AUTO PAN

1

2

3

4

PATTERN

 

123

SCAN

1

2

3

4

AUTO PLAY

 

 

 

OFF

English _39

00956B-NA_SCC-C7453N-ENG.indb 39

2009-08-13 오후 10:58:

Image 39
Contents Smart Dome Camera Overview English  Overview FCC Statement Important safety instructions Contents What’s Included FeaturesAt a Glance CameraFrame SET Optional Accessories for Installation Installation & connectionEnglish Cable PrecautionsHousing PreparationInstallation Bush Power BNC Cable Bush 24V CableHousing Mount PIN BushHook Protective Camera Tape Cover 22P Connector Housing RackHousing Camera Screws Cover Dome Gasket Dome Frame SETSamsung Half Samsung Full Initial SetupCamera Address Setup Communication Protocol SetupFactory default is 9600 BPS Baud Rate SetupSetting RS-422A/RS-485 Termination Use pins #5, #6 of SW603 to set the baud rateSame address in the network RS-422A/RS-485 Full Duplex OrganizationCONTROLLER/DVR Power Source Connecting with Other deviceConnecting to a monitor Monitor Alarm Alarm OUTTo connect Alarm To connect Alarm OUTTo connect the controller Connecting the adaptor cable Power SupplyAdaptor Board How to use the keyboard controller Using OSD iconsCamera will resume the last run operation Main Menu Profile EXT Burst DAY ModeNight Burst Location Specify the display position of the camera ID You can configure the general settings of the camera moduleCamera SET Camera IDAGC  Manual Adjust the iris level manuallyWith this, you can adjust the AGC level of a IrisSENS-UP MotionDNR ShutterDAY/NIGHT You can specify a recording mode according to the sceneFlickerless XDRAuto Switch or Auto Focus NeededSET-AUTO SET are not available White BAL DAY/NIGHT Digital Zoom Zoom SpeedDisplay Zoom Display P/TPOSI/NEGA SyncAGC Color SUP ReverseAdvanced You can enable the motion detection and tracking functionsWhen multiple motions continue arbitrarily Intelligent VideoDisplay ResolutionAlarm OUT Privacy ZonePreset Select Position and adjust PAN Select the preset numberYou can set the Auto PAN, PATTERN, and Auto Play Auto Pan SetupSettings so define them again after the operation Auto SETPosition Direction Left Endless OFF Speed Pattern Setup Scan SetupSelect the Start and move the camera using pan/tilt/zoom ~ 511 for Preset Auto Play SetupZone SET You can set the north direction and the zone coverageSelect Main MENU-ZONE SET Select Main MENU-ALARM SET Alarm SET Auto SET Sets the pattern and scan Other SET Clock SETProportional P/T Factory DefaultsPassword OSD ColorSelect Main MENU-SYSTEM Info CommunicationSystem Info You can check the system informationYou can set the language of the user interface LanguageFunction Key Shortcut KeysSpecifications Smart Dome CameraINT/LINE Lock Tilt PANProduct Appearance 00956B-NASCC-C7453N-ENG.indb 2009-08-13 오후