Samsung SCC-C7453N user manual To connect Alarm OUT, To connect the controller

Page 20

installation & connection

To connect ALARM IN

1.Connect one end of the external device's signal line to a corresponding ALARM IN port of the monitor.

2.Connect the other end of the signal line to the earth-grounding [GND] port.

To connect ALARM OUT

1.Connect one end of the external device's signal line to a corresponding ALARM OUT port of the monitor.

2.Connect the other end of the signal line to the common [COM] port.

To connect the controller

Connect an external controller or DVR to the camera, with which you can adjust the camera.

1.Connect the Rx+ pin of the camera to the Tx+ pin of the controller.

2.Connect the Rx- pin of the camera to the Tx- pin of the controller.

3.Connect the Tx+ pin of the camera to the Rx+ pin of the controller.

4.Connect the Tx- pin of the camera to the Rx- pin of the controller.

Rx Tx

20_ installation & connection

00956B-NA_SCC-C7453N-ENG.indb 20

2009-08-13 오후 10:58:

Image 20

Contents Smart Dome Camera Overview English Overview FCC Statement Important safety instructions Contents Features What’s IncludedFrame SET At a GlanceCamera Installation & connection Optional Accessories for InstallationEnglish Precautions HousingPreparation CableInstallation Power BNC Cable Bush 24V Cable Housing MountPIN Bush Bush22P Connector Housing Rack Housing Camera Screws Cover Dome Gasket DomeFrame SET Hook Protective Camera Tape CoverInitial Setup Camera Address SetupCommunication Protocol Setup Samsung Half Samsung FullBaud Rate Setup Setting RS-422A/RS-485 TerminationUse pins #5, #6 of SW603 to set the baud rate Factory default is 9600 BPSRS-422A/RS-485 Full Duplex Organization Same address in the networkConnecting with Other device Connecting to a monitorMonitor Alarm Alarm OUT CONTROLLER/DVR Power SourceTo connect the controller To connect AlarmTo connect Alarm OUT Adaptor Board Connecting the adaptor cablePower Supply Camera will resume the last run operation How to use the keyboard controllerUsing OSD icons Main Menu Profile DAY Mode NightBurst EXT BurstYou can configure the general settings of the camera module Camera SETCamera ID  Location Specify the display position of the camera ID Manual Adjust the iris level manually With this, you can adjust the AGC level of aIris AGCMotion DNRShutter SENS-UPYou can specify a recording mode according to the scene FlickerlessXDR DAY/NIGHTSET-AUTO SET are not available Auto Switch or Auto FocusNeeded White BAL DAY/NIGHT Zoom Speed Display ZoomDisplay P/T Digital ZoomSync AGC Color SUPReverse POSI/NEGAYou can enable the motion detection and tracking functions When multiple motions continue arbitrarilyIntelligent Video AdvancedResolution Alarm OUTPrivacy Zone DisplayPreset Select the preset number Select Position and adjust PANAuto Pan Setup Settings so define them again after the operationAuto SET You can set the Auto PAN, PATTERN, and Auto PlayPosition Direction Left Endless OFF Speed Select the Start and move the camera using pan/tilt/zoom Pattern SetupScan Setup Auto Play Setup ~ 511 for PresetSelect Main MENU-ZONE SET Zone SETYou can set the north direction and the zone coverage Alarm SET Select Main MENU-ALARM SET Auto SET Sets the pattern and scan Clock SET Other SETFactory Defaults PasswordOSD Color Proportional P/TCommunication System InfoYou can check the system information Select Main MENU-SYSTEM InfoLanguage You can set the language of the user interfaceShortcut Keys Function KeyINT/LINE Lock SpecificationsSmart Dome Camera PAN TiltProduct Appearance 00956B-NASCC-C7453N-ENG.indb 2009-08-13 오후