VBrick Systems VB4000, VB6000, VB5000 Configuration Pump General, reserved for VBrick firmware

VBStar

Configuration: Pump > General

Click here to examine ...	Click on this link to examine hard drive content. You must know
	the user name and password to login to the FTP server and view
	content. You can use any FTP client application to access the
	hard drive using a URL like this: ftp://admin@<IP_Address>/D:
	Be sure to login to the D: drive as shown. Do not modify or
	store files on the C: drive. The C: drive has limited space and is
	reserved for VBrick firmware.
Pump Mode	Used to set the stream to be controlled manually or to
	automatically start at the VBStar Power-Up.
Pump File Name	This is the file that will "Pump". In batch mode, the Batch Base
	File Name is usually entered as the Pump File Name, the batch
	files will be played from the lowest numbered through the
	highest number. If a batch file name is entered with a particular
	batch file number, the file will be pumped using that file as the
	starting point. Any missing files in the series will be skipped and
	the next sequential file will play.
	Example: If files test1.mpg through test15.mpg exist and the
	user specifies test5.mpg, test5.mpg through test15.mpg will be
	played. After playing test15.mpg, test5.mpg will be played again,
	even though lower numbers of the file exist.
IR Enable	Is used to enable or disable the use of IR Controller to "Pump"
	the specified stream.
Batch Enable	If enabled, a series of files in a batch will be played sequentially.
	If disabled, only a single file will be played.

VBrick MPEG-2 Appliance Admin Guide 101