VBrick Systems VB5000, VB6000, VB4000 manual Configuration Pump Destination

Continuous Enable	If Once is selected the selected file or batch will play through to
	completion and stop. If Continuous Repump is selected, the
	selected file or batch sequence will be continuously played until
	the stop button is pressed or a different file is selected. When the
	file or batch has completed playing it wraps to the beginning and
	plays again.
Auto Pump New File	Can be enabled or disabled to allow any file to be automatically
	pumped on FTP reception. If batch mode is enabled, any file
	with the identified base name will be pumped on FTP reception.
	If batch mode is not enabled, any file FTP'd to the disk will be
	pumped on reception. Some special cases of operation following
	an FTP onto the hard drive.
	• If both Batch Mode is enabled and Continuous Enable is
	Continuous Repump, the FTP'd file that belongs to the series
	is played when its turn is reached. If it is not part of the
	series, it is not played.
	• If Batch Mode is enabled and Continuous Enable is Once, all
	files will be played. If the FTP'd file belongs to the series and
	has a greater index than the last file played, then the FTP'd
	file is played. Otherwise nothing happens.
	• If Batch Mode is disabled and Continuous Enable is
	Continuous Repump. The current file completes, and the new
	file is played continuously.
	• If Batch Mode is disabled and Continuous Enable is Once.
	The current file will be completed and the FTP'd file will
	start.
Pump State	Is a read only field that lets you know if the Pump is running or
	stopped.

Configuration: Pump > Destination 1

See MPEG-2 Configuration: Encoder > Destination 1/Destination2 on page 31.

102 © 2007 VBrick Systems, Inc.