Scientific Atlanta D9225 Sdgplfursurfhvvru, KBD=V#.## #.## is the installed software version

SA1INST=#,{,QVWDOOHU

The command is available for displaying current receiver settings, or for changing#####,the receiver#######/####.settings. Observe.##},#,##the following.####,##syntax.###,. ##.###,##.###,

INST polls the receiver for the current receiver settings. To change any setting, you must use all INST command options. The receiver responds by displaying the fol- lowing.

INST=#,{##.#####/####.##},#,##.####, ##.###, ##.###, ##.###, #, #####, #####

The accompanying table identifies each of the command parameters as displayed (from left to right), in order.

When using the INST command, a valid Downlink frequency or L-Band frequency must be specified. The INST command is valid only if Channel 0 is the current channel, and if any menu (except the Receiver Setup menu) is displayed. For more information about the current channel, see “Available Services menu”. No pa- rameters may be omitted when using this command.

,QWHUQDO￿6HFXULW\￿PLFURSURFHVVRU

The ISE command is available for polling the receiver to display the network ad- dress plus the installed software version for the Internal Security microprocessor, ISEincluding algorithm information. Observe the following syntax.

&￿￿ISE polls the receiver for network address and installed software version informa- tion (Internal Security microprocessor and algorithm), where ###-###-####-# is the network address, V#.## is the software version, (#) is the decryption algorithm type, and “-“ is displayed only if the ISE is not installed. The receiver responds by displaying the following

ISE=###-###-####-#, V#.##(#) -

Tble15Parameter.INSTcommandoptions						Optins
Fequency21..(Frequency. Mode(DownlinkMode)set				Downlink)if		0(Downlink),-15GHz)(L-Band1),or2(L-Band2).
or						Range(950-2150MHz,with250kHzresolution)
####.#####(L-Bandfrequency,Frequency,if -
6.	##.###C-Band])(LocalOscillator#2fre-					0-15GHz)
quencyModesetL-Band)						1(1/2),2(2/3),3(3/4),4(5/6)or5(7/8)
3	(FECRate)
4			#(SymbolRe)			330.8MS/s[variable-ratedecoders
5.		.			1fre-	only])ignoredinfixed-ratedecoders
quency[LowKu-Band])
7.	.		(Crossoverfrequency)			Range(10.7-15.0GHz)forDual-Ku[Downlink
10.#####(BouquetID)						0to65535
8.	(Polarization)					Mode](Auto),nly)1(Horizontal,Fixed),2(Vertical)or3
9.			(NetworkID)			(Vertical,Fixed)

###-###-####-# is the network address, V#.## is the software version and (#) is the decryption algorithm type, and "-" is displayed only if the ISE is not installed.

.H\SDG￿PLFURSURFHVVRU

The KBD command is available for polling the receiver to display the installed KBDsoftware version for the Keypad microprocessor. Observe the following syntax.

KBD polls the receiver for installed software version information (Keypad micro- processor). The receiver responds by displaying the following.

KBD=V#.##

V#.## is the installed software version.