Lexicon DD-8 manual Convenciones de la documentación

Page 33

DD-8Amplificadores de potencia

Convenciones de la documentación

Este documento contiene instrucciones generales sobre la seguridad, la instalación y el funcionamiento del amplificador de potencia DD-8. Es importante leer esta guía del usuario antes de usar el producto. Preste especial atención a las instrucciones sobre seguridad.

En este documento se utilizan los siguientes símbolos:

PRECAUCIÓN

ADVERTENCIA

Aparece en el componente para indicar la presencia de voltaje peligroso sin aislamiento dentro de la carcasa, que puede constituir peligro de descarga eléctrica.

Aparece en el componente para indicar instrucciones importantes sobre el funcionamiento y mantenimiento.

Advierte de que un procedimiento, práctica, estado o circunstancia similar, si no se realiza o sigue correctamente, podría provocar daños o muerte.

Advierte de que un procedimiento, práctica, estado o circunstancia similar, si no se realiza o sigue correctamente, podría provocar daños o la destrucción de una parte o la totalidad del producto.

NOTA:

Advierte sobre información que resulta esencial destacar.

FCC COMPLIANCE NOTICE

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Manual de funcionamiento

33

Image 33
Contents DD-8 Power Amplifier Watch for These Symbols Important Safety InstructionsDeclaration of Conformity Documentation Conventions Following symbols are used in this documentHighlights Getting StartedInstallation Options Installation ConsiderationsBasic Operation Channel Status Indicator LED’sFront Panel Standby ButtonBack Panel Bus OutputBus Input Output Level Controls Local InputsStereo/Mono Selection Local/Bus SelectionPower Save On/Off Signal Sense On/OffSpeaker Outputs Trigger In/Out To install a trigger cableAC Main Power Connector Troubleshooting Troubleshooting and MaintenanceMaintenance Humming sound is present in the audioIf all else fails… Specifications This page Intentionally Left Blank DD-8 Leistungsverstärker Bedienungsanleitung Dokumentationskonventionen Diesem Dokument werden die folgenden Symbole verwendetBesondere Merkmale Erste SchritteInstallationsmöglichkeiten InstallationsvoraussetzungenVorderseite BetriebStandby-Taste LED-Anzeigen für den Status der KanäleRückseite Bus-AusgangBus-Eingang Lokale Eingänge AusgangspegelsteuerungStereo-Mono-Auswahl Lokal-Bus-Auswahl LautsprecherausgängeEnergiesparzustand ein/aus Trigger-Eingang und -Ausgang Signalsensor ein/ausNetzstromanschluss So installieren Sie ein Trigger-KabelFehlerbehebung Fehlerbehebung und WartungDer Verstärker lässt sich nicht einschalten Die Tonwiedergabe wird plötzlich unterbrochenWartung Die Tonwiedergabe enthält ein summendes GeräuschWenn das alles nicht hilft … Spezifikationen Amplificador de potencia DD-8 Manual de funcionamiento En este documento se utilizan los siguientes símbolos Convenciones de la documentaciónCaracterísticas destacables IntroducciónOpciones de instalación Consideraciones sobre la instalaciónPanel frontal Funcionamiento básicoBotón de espera Indicadores LED del estado del canalPanel posterior Salida de busEntrada de bus Entradas locales Controles del nivel de salidaSelección Estéreo/Mono Selección Local/Bus Salidas de altavozAhorro de energía On/Off Entrada/salida de disparador Detección de señal On/OffConector principal de alimentación de CA Para instalar un cable de disparadorResolución de problemas Resolución de problemas y mantenimientoEl amplificador no se enciende Los niveles de audio difieren entre los canalesMantenimiento El audio presenta un zumbidoSi todo lo demás falla… Especificaciones Amplificateur de puissance DD-8 Mode demploi Conventions utilisées dans le présent document Les symboles suivants sont utilisés dans ce documentPoints essentiels DémarrageOptions d’installation Considérations relatives à l’installationFaçade avant Fonctionnement de baseBouton de mise en veille DEL indiquant l’état des canauxPanneau arrière Sortie BusEntrée Bus Contrôles du niveau de sortie Entrées localesSélection Stéréo/Mono Sélection Local/BusSorties de haut-parleurs Activation/désactivation de la détection de signal10. Déclencheur activé/désactivé Pour installer un câble de déclencheurConnecteur d’alimentation principale secteur Dépannage Dépannage et maintenance’amplificateur ne se met pas sous tension Les niveaux audio varient selon les canauxSi le problème persiste… Un bourdonnement se fait entendre sur l’audioCaractéristiques Rapport signal/bruitPuissance de sortie Réponse en fréquenceWhat is Covered? What is the Duration of this Warranty?How is Service Obtained? How do State Laws Relate to this Warranty?This page Intentionally Left Blank Product Registration This page Intentionally Left Blank DD-8Power Amplifiers
Related manuals
Manual 16 pages 47.89 Kb

DD-8 specifications

The Lexicon DD-8 is a powerful digital delay processor that has gained recognition among audio engineers and musicians for its versatility and high-quality sound processing capabilities. Renowned for its advanced features and technologies, the DD-8 offers unmatched performance in both studio and live settings.

One of the main features of the Lexicon DD-8 is its ability to deliver studio-quality delays with unprecedented precision. The device is equipped with multiple delay algorithms that cater to various audio applications, including classic analog-style delays, digital delays, and more complex modulation effects. Each algorithm is designed to produce a richness of sound that enhances any audio mix, making it an essential tool for creative sound design.

The DD-8 stands out with its comprehensive user interface. It incorporates a bright, easy-to-read display and intuitive controls, which allow users to navigate through parameters effortlessly. This includes the ability to adjust delay times, feedback settings, and modulation depths in real time. Additionally, the DD-8 features a dual-path design, enabling users to apply different delay settings to two separate channels simultaneously, providing greater flexibility for stereo effects.

In terms of connectivity, the DD-8 excels with its robust input and output options. It supports both analog and digital connections, including S/PDIF and AES/EBU formats, ensuring compatibility with a wide range of audio equipment. This makes it an ideal choice for both professional studios and live performance environments.

One of the standout technologies in the DD-8 is its sophisticated DSP (Digital Signal Processing) engine. This powerful processing unit allows for a high degree of customization and control over the audio signal, enabling users to achieve complex soundscapes. The engine also ensures minimal latency, making it suitable for real-time applications without compromising sound quality.

Furthermore, the Lexicon DD-8 is built with high-quality components that contribute to its reliability and durability. Whether used in a studio or on stage, the unit's rugged construction ensures it can withstand the rigors of frequent transport and use.

In summary, the Lexicon DD-8 is a versatile and powerful digital delay processor that combines advanced sound processing capabilities with an intuitive user interface. Its rich feature set, combined with high-quality sound and dependable performance, makes it a valuable asset for any audio professional seeking to elevate their audio productions. Whether for music production, live sound, or creative sound exploration, the DD-8 remains a top choice in the realm of audio processing technology.