Pioneer DEH-2150UB Other Functions, Setting the FM tuning step, Setting the AM tuning step

Black plate (16,1)

Section

02Operating this unit

2Press MULTI-CONTROL to display the

setting mode.

# To return to the previous display, press DISP/BACK/SCRL.

3Press MULTI-CONTROL to select the seg- ment of the clock display you wish to set. Each time you press MULTI-CONTROL, one segment of the clock display is selected. Hour—Minute

As you select segments of the clock display, the selected segment blinks.

4Turn MULTI-CONTROL to put a clock right.

Setting the FM tuning step

The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz.

!If seek tuning is performed in 50 kHz steps, stations may be tuned in imprecisely. Tune in the stations with manual tuning or use seek tuning again.

!The tuning step remains at 50 kHz during manual tuning.

1Use MULTI-CONTROL to select FM STEP in the initial setting menu.

Refer to Adjusting initial settings on the pre- vious page.

2Press MULTI-CONTROL to display the setting mode.

3Turn MULTI-CONTROL to select the FM tuning step.

50KHZ (50 kHz)—100 KHZ (100 kHz)

4Press MULTI-CONTROL to determine

the selection.

# Even if the menu has been cancelled before determination, operation is settled.

Setting the AM tuning step

The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. When using the tuner in North, Central or South America, reset the tuning step from 9 kHz (531 kHz to 1 602 kHz allowable) to 10 kHz (530 kHz to 1 640 kHz allowable).

1Use MULTI-CONTROL to select AM STEP in the initial setting menu.

Refer to Adjusting initial settings on the pre- vious page.

2Press MULTI-CONTROL to display the setting mode.

3Turn MULTI-CONTROL to select the AM tuning step.

10KHZ (10 kHz)—9 KHZ (9 kHz)

4Press MULTI-CONTROL to determine

the selection.

# Even if the menu has been cancelled before determination, operation is settled.

Switching the auxiliary setting

It is possible to use auxiliary device with this unit. Activate the auxiliary setting when using auxiliary device connected to this unit.

1Use MULTI-CONTROL to select AUX in the initial setting menu.

Refer to Adjusting initial settings on the pre- vious page.

2Press MULTI-CONTROL to turn AUX on.

# To turn AUX off, press MULTI-CONTROL again.

Other Functions

Using the AUX source

You can connect an auxiliary device to this unit using a stereo mini plug cable.

16 En

<YRD5220-B/S>16