Jensen VM9413 Parking Brake Inhibit, Monitor Movement Mechanism, Parameter Adjustment Procedure

VM9413

Parameter Adjustment Procedure

1.Enter Picture Quality Setting Mode:

Press the PIC button on the remote control or press and hold the WIDE/PICTURE button (22) on the monitor.

2.Select Item to Set:

Use the up/down joystick buttons to select “BRIGHT” or “CONTRAST”.

3.Set Parameters:

Use the left/right joystick buttons to modify the settings.

4.Exit Picture Quality Setting Mode:

Press the PIC button on the remote control or the WIDE/ PICTURE button on the monitor.

Parking Brake Inhibit

When the pink "Parking" wire is connected to the vehicle Parking Brake circuit, the front TFT monitor will display video when the Parking Brake is engaged. (When the pink wire is grounded via the Parking Brake circuit, video will be displayed.)

Monitor Movement Mechanism

If an obstruction occurs in the monitor path, the following protective measurements can be executed to prevent damage to the mechanism or monitor:

Table 3: Monitor Protective Measures

Obstruction	Self	OPEN Button	Power
	Protection	Pressed	Reconnected
Monitor load-	Unit stops at	Monitor fully	Monitor is auto-
ing out hori-	obstruction	extended hori-	matically
zontally	point	zontally	loaded into unit
Monitor load-	Unit stops at	Monitor fully	Monitor is auto-
ing in hori-	obstruction	extended hori-	matically
zontally	point	zontally	loaded into unit
Monitor load-	Unit stops at	Monitor swiv-	Monitor swiv-
ing out verti-	obstruction	els back to the	els back to the
cally	point	unit	unit
Monitor load-	Unit stops at	Monitor swiv-	Monitor swiv-
ing in verti-	obstruction	els back to the	els back to the
cally	point	unit	unit

After the protective procedure is executed, normal operation is resumed by pressing the OPEN button (1) or disconnecting and reconnecting the power.

8