Menu Navigation
Menus are extensively used for configuring, adjusting or reconfiguring the projector.
Navigating through the menu
JJOperating procedure
1111 Press <MENU> button.
[MAIN MENU] appears on the screen.
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
DISPLAY OPTION
PROJECTOR SETUP
P IN P
TEST PATTERN
SIGNAL LIST
SECURITY
NETWORK
MENU SELECT
ENTER SUB MENU
2222 Press ▲▼ to select the desired item.
The selected item is highlighted in orange.
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
DISPLAY OPTION
PROJECTOR SETUP
P IN P
TEST PATTERN
SIGNAL LIST
SECURITY
NETWORK
MENU SELECT
ENTER SUB MENU
3333 Press <ENTER> button to establish your selection.
The submenu for the selected option will now open.
POSITION
SHIFT |
|
|
|
ASPECT | DEFAULT |
| |
ZOOM |
|
|
|
CLOCK PHASE | 0 |
|
|
GEOMETRY | OFF |
| |
|
|
|
|
MENU SELECT
ENTER SUB MENU
4444 Press ▲▼ button to highlight the desired adjustment item, then press ◄► to change or adjust the parameter value.
For some items, an individual adjustment screen containing a bar scale will appear as shown in the diagram below when ◄► is pressed.
CONTRAST | 0 |
|
|
ADJUST
Note
zzPress <MENU> button to return to the previous menu. zzSome menu items may not be valid for certain signal formats applied to the projector. The menu items that
cannot be adjusted or used are shown in gray characters, and they cannot be selected.
zzIf no button is pressed for approx. 5 seconds while the individual adjustment screen is displayed, the screen will return to the previous page.
JJResetting to the factory default
If an adjustment item is selected and <DEFAULT> button is pressed, the adjustment value will return to the factory default setting.
Press
CONTRAST | 0 |
|
|
ADJUST
Note
zzYou cannot reset all the settings at a time to the factory default settings. To reset all the settings to the factory defaults, refer to “INITIALIZE” of “PROJECTOR SETUP menu” (Æ 86 page).
zzSome menu items are not available to reset by pressing <DEFAULT> button. Adjust each menu item manually. zzThe triangle mark under the bar indicates factory default setting and the square indicates the current setting.
The triangle mark position varies by the selected input signals.
Current setting
Settings
Default setting
ENGLISH - 49
