Projecting
If the lens is heavy or the projector is installed so that it is tilted, the lens may be tilted, resulting in the focus becoming unbalanced.
In such a case, refer to the figure 3 and table below, and follow the procedure below to perform adjustment.
QQAdjustment procedure
Display the internal test pattern grid, and defocus the image.
Adjust the lens focus till one or more sides of the grid comes into focus. Note the appropriate screws for the
Loosen the locking screws for each of the adjustment screws 
, 
and 
as needed, following the indications in the example. The screws to be adjusted correspond to the
Attention
zzMake adjustments in up to two places, and fully turn the screw clockwise in at least one place.
Turn the adjustment screws (corresponding to the locking screws loosened in step 3) counterclockwise slightly till the
Readjust the lens shift position with the remote if needed.
Refocus the image as in steps 1 and 2 above. Fine adjust the focus evenness as needed, as described in step 4.
When adjustment is complete, tighten the locking screws. 
Adjust the Focus.
Tool to be used : Allen hex socket driver or Allen wrench (2.5 mm diagonal hexagon)
An Allen wrench is supplied with the
Figure 3 : Relation between the adjustment place and adjustment screw
Projector
Screen
Adjustment place :
The place where the
| When optimal focus point | When optimal focus point | When optimal focus point | When optimal focus point |
| is at the back of screen | is at the back of screen | is at the back of screen | is at the back of screen |
| for V up | for V bottom | for H left | for H right |
| Turn counterclockwise | |||
| Turn counterclockwise | Turn counterclockwise | ||
| Turn counterclockwise | Turn counterclockwise |
Basic Operation
ENGLISH - 45
