ENGLISH - 37
Getting Started
Removing/attaching the projection lens (optional)
Move the lens to the home position before replacing or removing the projection lens. (Æpage 43)

How to install the projection

lens

Align the mark (orange) on the 1 )
projection lens with the mark on
the projector ( on the left side of
LOCK), then insert the lens and turn it
clockwise until there is a click.
Fix the projection lens with the 2 )
attached “Lens xing screw”. Û
Tighten the screw into the rst screw hole
z
on the right side of the mark (orange) of the
projection lens with a Phillips-head screwdriver.
(There is not the projection lens xing tap hole
on all the lenses.)

How to remove the projection

lens

Remove the “Lens xing screw”. 1 ) Û
Remove the rst screw on the right side of the
z
mark (orange) of the projection lens with a
Phillips-head screwdriver.
While holding down the “LOCK 2 )
button”, turn the projection lens
counterclockwise, and then pull it off.
Turn the projection lens counterclockwise until
z
its mark (orange) is aligned with the mark on
the projector ( on the left side of LOCK).
Some types of the lens do not have the projection lens xing screw hole.:
Û
Attention
Do not touch the lens signal receiver. Dust or dirt may cause defective contact.
z
Do not touch the surface of the projection lens with your bare hands.
z
Store the replaced lens where it will be free from vibration and impact.
z
Turn the projection lens counter clockwise to conrm that it does not come out.
z
LOCK button